LM Guide THK - Industrial Technologies

Индастриал Технолоджис www.industrial‐technologies.com.ua +38 044 498 21 94[Greasing Hole for Model SRG]Model SRG allows lubrication from both the side and top faces of the LM block. The greasing hole ofstandard types is not drilled through in order to prevent foreign material from entering the LM block.When using the greasing hole, contact THK.When using the greasing hole on the top face of models SRG-R and SRG-LR, a greasing adapter isseparately required. Contact THK for details.φ D2 depth 1φ D0(M6 pilot hole)Ve1e0f0Greasing hole on the top faceSide nippleUnit: mmModel No.Pilot hole for side nipple Applicable Greasing hole on the top facee0 f0 D0nippleD2 (O-ring) V e115A15V4 4 2.9 PB107 9.2 (P6) 0.5 5.520A20LA 4 5 2.9 PB107 9.2 (P6) 0.5 6.520V20LV 4 5 2.9 PB107 9.2 (P6) 0.5 6.525C25LC 6 6.3 5.2 M6F 10.2 (P7) 0.5 625R25LR 6 10.3 5.2 M6F 10.2 (P7) 4.5 630C30LC 6 5.8 5.2 M6F 10.2 (P7) 0.4 630R30LR 6 8.8 5.2 M6F 10.2 (P7) 3.4 6SRG35C35LC 6 6 5.2 M6F 10.2 (P7) 0.4 635R35LR 6 13 5.2 M6F 10.2 (P7) 7.4 645C45LC 7 7 5.2 M6F 10.2 (P7) 0.4 745R45LR 7 17 5.2 M6F 10.2 (P7) 10.4 755C55LC 9 8.5 5.2 M6F 10.2 (P7) 0.4 1155R55LR9 18.5 5.2 M6F 10.2 (P7) 10.4 1165LC 9 13.5 5.2 M6F 10.2 (P7) 0.4 1065LV 9 13.5 5.2 M6F 10.2 (P7) 0.4 1085LC 15 22 8.2 PT1/8 13 (P10) 0.4 10100LC 15 23 8.2 PT1/8 13 (P10) 0.4 10Note) The greasing interval is longer than that of full-roller types because of the roller cage effect. However, the actual greasinginterval may vary depending on the service environment, such as a high load and high speed. Contact THK fordetails.Industrial TechnologiesA1-362