LM Guide THK - Industrial Technologies

Индастриал Технолоджис www.industrial‐technologies.com.ua +38 044 498 21 94Point of SelectionSetting Conditions[Symbol for Number of Axes]With the LM Guide, the normal and high-accuracy grades are interchangeable when two or moreunits of the LM Guide are used in combination on the same plane. However, when using two or moreunits of a model of precision or higher grade, or with a radial clearance of C1 or C0, specify the numberof LM rails (symbol for number of axes) in advance.(For accuracy standards and radial clearance standards, see A1-94 and A1-89, respectively.)Model number codingSHS25C2SSCO+1000LP -Model number (details are given on thecorresponding page of the model)[Symbol for Number of Axes]Symbol for number of axes:noneSymbol for number of axes:Symbol for number of axes:Required number of axes: 1 Required number of axes: 2 Required number of axes: 2Symbol for number of axes:Symbol for number of axes("II" indicates 2 axes. No symbol for a single axis)Note:When placing an order, specifythe number in multiple of 2 axes.Symbol for number of axes:Note:When placing an order, specifythe number in multiple of 2 axes.OtherRequired number of axes: 3 Required number of axes: 4 Required number of axes: 2LM GuideIndustrial TechnologiesNote:When placing an order, specifythe number in multiple of 3 axes.Using 2 axes opposedto each otherNote:When placing an order, specifythe number in multiple of 4 axes.A1-35