LM Guide THK - Industrial Technologies

Индастриал Технолоджис www.industrial‐technologies.com.ua +38 044 498 21 94OptionsPlate Cover SV -- Steel Tape SP[Mounting Procedure for Plate Cover SV](1) Attach slide pieces to the plate cover.Place the slide pieces on the plate coverwith their chamfered sides facing outward,hold the plate cover with the slide piecesand the securing plates, and then securethem with countersunk screws.(2) Use an LM block mounting/removing jig toremove the LM block from the LM rail, andthen mount the fixing-jigs onto the LM rail.Identify the positions of the mounting holeson the fixing jigs, then secure the jigs withhexagonal-socket-head type bolts.(3) Temporarily secure either slide piece.Insert either slide piece into one of the fixing-jigs,then attach the slide piece to theLM rail's end face using the tension adjustmentbolt and gently secure the bolt untilthe bolt head is inside the fixing-jig.(4) Temporarily secure the other slide piece.Temporarily secure the other slide piece inthe same manner as above.(5) Apply tension to the plate cover.Apply tension to the plate cover by evenlysecuring the tension adjustment bolts onboth ends of the LM rail. Make sure there isonly a small difference between the H andH' dimensions in Fig.5. If the difference istoo large, there may be no interference lefton either end.(6) Mount the LM block on the LM rail.Identity the reference surface of the LM railand the LM block, then insert the LM railinto the LM block using the LM blockmounting /removing jig.Note1) When removing or the mounting the LM block, usemuch care not to let the balls fall off.Note2) The plate cover is an ultra-thin stainless steel(SUS304) plate. When handing it, use much care notto bend it.Note3) The plate cover is available for models SNR/SNS35to 65 and models NR/NRS35 to 100.Slide pieceFixing plateHFig.1Fig.2Fig.3Fig.4Fig.5Plate coverChamferPosition for fixingLM railTension adjustment boltMountingholeH’LM Guide (Options)Industrial TechnologiesA1-343