LM Guide THK - Industrial Technologies

Индастриал Технолоджис www.industrial‐technologies.com.ua +38 044 498 21 94OptionsPlate Cover SV -- Steel Tape SP[Dimensions, applicable model number]• Specification TableH• Supported model numbersGC caps are suitable for various different model numbers.ModelNo.LM railmountingboltSSRModel number codingSRφDSNRSNSNRNRSUnit: mmModel No. Outer diameter D Thickness HGC5 9.86 2.5GC6 11.36 2.5GC8 14.36 3.5GC10 17.86 3.5GC12 20.36 4.6GC14 23.36 5.0GC16 26.36 5.0GC22 35.36 5.0GC24 39.36 5.0Note1) LM guides with GC caps are special rails.Note2) They cannot be mounted on stainless steel LM rails or LM rails that have undergone surface treatment.Note3) If this product will be used in special environments, such as in a vacuum or at very low or high temperatures, contactTHK.Note4) GC caps are not sold individually. They are sold as a set with LM guides.Note5) The openings of LM rail mounting holes are not chamfered. Take care not to injure your hands while working.Note6) After fitting GC caps, the upper surface of the LM rail must be flattened and cleaned (wiped).Note7) If you wish to fit GC caps for a single rail, use the sample model number configuration shown below.• Mounting methodThe procedure for inserting a GC cap into amounting hole consists of using a flat aligningfitting to gradually punch the cap into the holeuntil it is level with the upper surface of the LMrail, as shown in the figure. Fit GC caps withoutremoving the LM rail from the LM block.LM Guide model numberSHSHSRHCRSCRCSRSHWHRWSRGSRN SRW GSR HR NSR-TBCGC5 M5 20 20 25 25X 20 20 — 20 — 20 2042 20GC6 M625Y 25Y2530 30 25 25 35 25 — 25 —30 3030GC8 M8 35 35 35 3530 3030255550— 3035 3535306540GC10 M10 — 45 — — — — 60 — 70 35 3575 50GC12 M12 — 55 45 45 45 45 — 45 85 — 4085 70GC14 M14 — — 55 55 55 — — 55 100 — — —GC16 M16 —708565 65 65 65 — 65 130 — 50105 —GC22 M22 — — 85 85 85 — — 85 150 — — —GC24 M24 — 120 — — 100 — — 100 — — — —SNR45 LR 2 QZ KKHH C0 +1200L P - GCModel No.Type ofLM blockWith QZLubricatorNo. of LM blocksused on the same railContaminationprotection accessorysymbol(Example) SNR45LR2QZKKHHC0+1200LPGCLM rail length (in mm)Radial clearance symbolNormal (No symbol)Light preload (C1)Medium preload (C0)With GC cap (Note5)Symbol for No. of rails used on the same plane (Note5)Accuracy symbolNormal grade (No Symbol)/High accuracy grade (H)Precision grade (P)/Super precision grade (SP)Ultra precision grade (UP)With GC cap* Add the symbol (GC) to the end of the model number.Plastic hammerFlat metal pieceLM Guide (Options)Industrial TechnologiesA1-341