Lounge Chairs - Knoll

Designer(s):
Emanuela Frattini
Order Code
Example: P4S-BOXM-PR-A
P4S-
BOXM-
PRA
Medium shallow plexus box,
prewired
A Andonized legs
Specify:
1. Plexus box size
2. Specify Duplex A and X or B and Y
3. Andonized finish
Can also specify:
1. Communication outlets, refer to page
358.
2. Prewired leg, refer to page 358.
3. Jumper to connect plexus boxes
(male/male), refer to page 358.
4. Jumper to connect 1st plexus box to
leg (female/male), refer to page 358.
Emanuela Frattini
Propeller� Electrical
Pre-Wired Plexus Boxes
description pattern no. type w d h
P4S-BOXM-PR medium shallow box,
pre-wired
P4S-BOXJ-PR jumbo shallow box,
pre-wired
P4SD-BOXM-PR double medium shallow
box, pre-wired
Finishes
Plexus Box lid/infeed leg finishes:
Aluminum (suffix A)
P4S-BOXM-PRA-(A) one duplex
A, one
duplex X,
room for 3
data plates
P4S-BOXM-PRB-(A) one duplex
B, one duple
Y, room for 3
data plates
P4S-BOXJ-PRA-(A) two duplex
A, two
duplex X,
room for 4
data plates
P4S-BOXJ-PRB-(A) two duplex
B, two
duplex Y,
room for 4
data plates
P4SD-BOXM-PRA-(A) 2 duplex A,
2 duplex X,
room for 6
data plates
P4SD-BOXM-PRB-(A) 2 duplex B,
2 duplex Y,
room for 6
data plates
352
Features
Pre-wired Plexus Boxes:
The pre-wired Plexus Box offers
permanet electrical power and data
access at the table top. The data and
electrical receptacles are angled at 60
degrees for easier access. Additional
data faceplates are located on box floor.
The extruded aluminum hinge lid
features a brush seal, allowing wires to
pass when lid is closed.
10.5� 7� 2.8�
10.5� 7� 2.8�
20.5� 7� 2.8�
20.5� 7� 2.8�
10.5� 12.5� 2.8�
10.5� 12.5� 2.8�
All power and communication wiring is
completely seperated by a metal septum
to avoid interference.
The Plexus Box is a four-circuit,
eight-wire power distribution system that
includes two 20-amp convenience
circuits (A,B), with neutral and ground
and two protected 20-amp circuits (X,Y)
with separate neutral and ground. All
power outlets are pre-configured to avoid
circuit overload. If several Plexus Boxes
are connected together, alternate
configurationsA&Bforoptimal load
distribution. The pre-wired system
consists of three components: