Lounge Chairs - Knoll

Plexus Box Connectivity options:
Plexus Boxes are available with three connectivity options for either temporary or permanent installation.
Plexus Box with Cordset For temporary power and communications access.
P4( )-BOX( )-PP
Use existing leg.
Empty Plexus Box For hard-wired power and communications access. Compatible with legs shown below.
P4( )-BOX( )-E
Training leg
Conference leg
P4-RWIN4-RE (right) P3-CLEG-PE
P4-RWIN4-LE (left)
Trapezoid leg
P4-RWIN4-TE
C-Leg
P4-RWIN4-CRE (right)
P4-RWIN4-CLE (left)
Pre-wired Plexus Box For permanent power and communications access. Compatible with legs shown below.
P4( )-BOX( )-PR
Connectivity
Plexus Box with Cordset:
The Plexus Box with Cordset offers
temporary power and
communications access, comprising
a single electrical circuit with a
3-prong plug. The 15’ cable can
simply be channeled through the
Propeller leg to connect to standard
floor or wall outlets. Leg that is
shipped with the Propeller table is
used with the Plexus box with
Cordset.
Plexus Boxes with Cordset simply
rest in the table cutout. Do not
attach permanently to the table to
comply with UL requirements. This
option is not available for New York
and Chicago.
Training leg
P4-RWIN4-R (right)
P4-RWIN4-L (left)
Conference leg
P3-CLEG-PR
Empty Plexus Boxes for hardwiring:
The empty Plexus Box for
hardwiring offers permanent power
and data access and has room for
wiring up to four-circuits. A special
empty infeed leg (E) must be
specified to bring wires from
building power supply to first empty
Plexus Box. Suitable for all regions.
Pre-wired Plexus Boxes:
The Pre-wired Plexus Box offers
permanent power and data access.
A special Pre-wired infeed leg (R)
must be specified to bring wires
from building power supply to first
pre-wired Plexus Box.
Jumper cables connect individual
pre-wired Plexus Boxes together
and connect the first plexus Box to a
pre-wired infeed leg. Suitable for
most regions if connected to
building power by licensed
electrician.
Trapezoid leg
P4-RWIN4-T
345
Construction
T-Leg
P3-TLEGU-PE
C-Leg
P4-RWIN4-CR (right)
P4-RWIN4-CL (left)
Empty Plexus boxes attach to table
via clamps from underneath the
table top. Pre-wired and Cordset
Plexus Boxes simply rest in the
table cutout. Accomodates table
thickness from 1� to 1 1 /2�.
T-Leg
P3-TLEGU-PR
Cutout options
KnollStudio
Plexus cutout locations:
For cutout locations see chart on
specific product pages. Boxes ship
with actual cutout template in case
cutouts need to be done in the field.