HIMax Safety Manual - Tuv-fs.com

HIMax2 Intended Use2.3.2 Mechanical RequirementsThe following table lists the key tests and limit values for mechanical requirements:IEC/EN 61131-2Mechanical testsVibration immunity test:5...9 Hz / 3.5 mm9...150 Hz, 1 g, EUT in operation, 10 cycles per axisShock immunity test:Table 4:Mechanical Tests15 g, 11 ms, EUT in operation, 2 cycles per axis2.3.3 EMC RequirementsHigher interference levels are required for safety-related systems. HIMax systems meetthese requirements in accordance with IEC 62061 and IEC 61326-3-1 (DIS). See column"Criterion FS“ (Functional Safety).IEC/EN 61131-2 Interference immunity tests CriterionFSIEC/EN 61000-4-2 ESD test: 6 kV contact, 8 kV air discharge -IEC/EN 61000-4-3RFI test (10 V/m): 26 MHz...1 GHz, 80 % AMRFI test (20 V/m): 26 MHz...2.7 GHz, 80 % AM: EN298-20 V/MIEC/EN 61000-4-4 Burst test: 2 kV power supply-, 1 kV signal lines 4 kVIEC/EN 61000-4-12 Damped oscillatory wave test2.5 kV L-,L+ / PE1 kV L+ / L -Table 5:Interference Immunity TestsIEC/EN 61000-6-2 Interference immunity tests CriterionFSIEC/EN 61000-4-6 High frequency, asymmetrical10 V, 150 kHz...80 MHz, AM20 V, 150 kHz...80 MHz, AM: EN 298 20 VIEC/EN 61000-4-3 900 MHz pulsesIEC/EN 61000-4-5 Surge: 2 kV, 1 kV 2 kV /1 kVTable 6:IEC/EN 61000-6-4EN 55011Class ATable 7:Interference Immunity TestsNoise emission testsEmission test:radiated, conductedNoise Emission TestsHI 801 003 D Rev.2.0 Page 13 of 70