SAM4s SPS-2000 Operators Manual.pdf - Parklandbm.com

Safe Operation• Do not locate your SAM4s SPS-2000 in a damp or wet environment. Avoid highhumidity, direct sunlight and temperature extremes.• Always plug your SPS-2000 into a grounded three-prong outlet. Never use two-prongadaptors or ungrounded outlets.• Check to make sure the power outlet provides the correct voltage: (120V +/- 10%).• Immediately disconnect the ECR from the power source in case of spilled liquid in theECR, smoke, or strange smells. Call your authorized dealer for assistance.• Do not operate the ECR with wet hands.• Use a soft dry cloth to clean the ECR cabinet. Do not use wet clothes or solvents.• Do not open the ECR case to attempt repairs. Dangerous voltages can cause shock.Service attempts by untrained personnel can cause unnecessary damage to your ECR.ECR Power Requirements• Be aware that other electrical devices on the same circuit can cause your ECR tomalfunction. Avoid plugging your ECR into outlets where other high-current devices areconnected.• Be aware that power quality issues, including voltage fluctuations, electrical noise,spikes, outages, interruptions, and other power viruses can disrupt or damage modernelectronic equipment, including ECRs and PCs.• When ECRs are interconnected in networks, connected to PCs or where communicationscables connect peripherals, particular care must be taken with power sources andcommunication cable routing. Your authorized dealer can provide detailed powerspecifications for these applications. Failure to implement installation requirements fornetworked systems may cause system failures and/or poor system performance.8 • Introduction SAM4s SPS-2000 Operator Manual v1.13