SAM4s SPS-2000 Operators Manual.pdf - Parklandbm.com

Initialize EFTSelect Initialize EFT to verify communications, software versions and installed networks.List of Installed NetworksStatus of InstalledDATE 5/24/2004 THU TIME 16:15** LIST INSTALLED NETWORRKS **CHK DEN --- --- VER:3.89OFF ON OFF OFFEMPLOYEE1 NO.000019 REG 01Software VersionOpen BatchManual batch opening and closing may be required by your payment processor. If required,it is recommended to open a new batch right after closing today’s batch, so it is ready to gofor the next day.Touch OPEN BATCH. No printing takes place.Close Current Batch/ Close Current Batch with DebitManual batch opening and closing may be required by your payment processor. TouchCLOSE CURRENT BATCH. or CLOSE BATCH WITH DEBIT if the batch containsdebit transactions. The message “WAITING RESP.” displays. When communication iscomplete, the Local Batch Status prints and the batch is closed.Change Batch NumberThe change batch number command is used to assign a new batch number to an existingbatch. It is used with certain credit card processors to rectify settlement problems. It is usedinfrequently. (Attempt to change batch number will be denied if bank does not allow thefeature.)104 • Reports SAM4s SPS-2000 Operator Manual v1.13