ContiTech Force Transmission Data sheet and instruction of use ...

More documents

Recommendations

Info

Conveyor Belt GroupContiTech Force TransmissionCORREX ® -WhiteLarge RhombusStatus 2007Subject to changeDescription:White NBR - compound. Oil - & grease resistant.Profildepth: 2 to 4 mm.Parameters Measurement Physical Values(mean value)DIN StandardSpecific weight* g / cm 3 1.20 53550Shore hardness Shore A 55 53505Tensile strength N / mm 2 10 53504Elongation at break % 620 53504Abrasion mm 3 300 53516* Material subject to wearAvailability: Large RhombusThicknessmmWidth1400 mm8 LL = Stock itemThe contents of this publication are the result of many years of research and experience gained in application technology.All information is given in good faith but without gurantee
Conveyor Belt GroupContiTech Force TransmissionRubber-Metal-Bonding(Tacky Back Material)Status 2007Subject to changePreparationooWipe the metal surface and the tacky back with a lint free cloth and RCE Cleaning Solution.The metal surface has to be prepared with an angle grinder and/or preferably sand- and/or grit blasted. Grit16 and/or 24. Remove dust with hand brush and/or vacuum cleaner. Do not use compressed air, since themoisture/oil residues could influence the bonding strength.Cold BondingooStir CONTI PLUS ® , and apply one coat.Drying time: min. 30 minutes; handling period max. 3 weeks at room temperatureMix CONTI SECUR ® BFA and 5% RE Activator(1x 0,8 l tin CONTI SECUR ® BFA with 1 bottle RE Activator 40g)Apply one thin coat of CONTI SECUR ® BFA on metalDrying time: min. 30 min. at room temperatureRemark: do not use a short bristled brush, otherwise the already applied CONTI PLUS ® might bedesolved. I.e. use a normal brush.o Cut rubber sheet to size.o Apply second coat of CONTI SECUR ® BFA on metal, and one coat on tacky back of rubber sheet.Drying time: back of the hand test, max. 15 minuteso Join the rubber sheet and the metal surface, and apply pressure with a hand stitcher and/or a mallet, startingat the centre.Attention: the pressure need to be applied only briefly.The final bonding strength will be achieved after 24 hours.Coatings overview:Coating withDrying time at room temperature1 CONTI PLUS ® min. 30 minutes max. 3 weeks1 CONTI SECUR ® BFA min. 30 minutes2 CONTI SECUR ® BFA Back of the hand test, max. 15 minutesAttention:Using the cold bonding method the surfaces should have a minimum temperature of 10°C.Otherwise warm up the surfaces.The contents of this publication are the result of many years of research and experience gained in application technology.All information is given in good faith but without guarantee
Page 1 and 2: Conveyor Belt GroupContiTech Force
Page 3 and 4: Conveyor Belt SystemsContiTech Forc
Page 7 and 8: Conveyor Belt SystemsContiTech Forc
Page 15: Conveyor Belt GroupContiTech Force

ContiTech Force Transmission Data sheet and instruction of use ...

Create successful ePaper yourself

Delete template?

Save as template?