Controller HX8258 datasheet - M-COMP

HX8258-A1200CH TFT LCD Source Driver with TCONDATA SHEET V02Pin nameTENI/OSettingDescriptionRPI1/2 I H/L Repair OP input.RPO1/2 O H/L Repair OP output.V1~V10 I H/LUsed as reference voltage input pins.Hold the reference voltage fixed during the period of LCD driveoutput. To ensure the correct analog voltage is output from D/Aconverter, the V1~V10 must be stable before D/A conversion.VDDA>V1>V2>V3>V4>V5>V6>V7>V8>V9>V10>VSS.Work with RESL[2:0], LRRESL[2:0] ID[1:0]Sample cycleLR = H LR = LChannel Number00 1 ~ 400 401 ~ 800 1200CH (S1 ~ S1200)000/00101 401 ~ 800 1 ~ 400 1200CH (S1 ~ S1200)(800X480/10800X600)NA1100 1 ~ 342 683 ~ 10241026CH (S1 ~ S513/S688ID[1:0] I H/LSPCKSDISPENSDOCKVOEVSTVDSTVUHimax ConfidentialIIIOOOOOHLHLHLHLHLHLHLH010/011(1024X600/1024X768)~ S1200)01 343 ~ 684 341 ~ 6821026CH (S1 ~ S513/S688~ S1200)10 685 ~ 1024 1 ~ 3401020CH (S1 ~ S513/S688~ S1194)11 NA00 1 ~ 400 1 ~ 400 1200CH (S1 ~ S1200)01111(400x240) 10NA11Serial port Clock. (Default pull high).Short SPCK to GNDSerial port Data input. (Default pull high).Short SDI to GNDSerial port Data Enable Signal. (Default pull high).Short SPEN to GND3-Wire serial bus data outputFloating SDOGate driver clock.Floating CKVEnable output control of gate driver.Floating OEVStart pulse for gate driver.When UD=L, STVD is output.When UD=H, STVD is Hi-Z.Floating STVDStart pulse for gate driver.When UD=L, STVU is Hi-Z.When UD=H, STVU is output.L Floating STVUH Reverse of UD.UDB OL Floating UDBH Internal link to UD.UDP OL Floating UDPSO1~SO1200 O H/L Output driver signal.TEST[1:0] I H/L Test pins. (Default pull low).TESTG[1:0] I H/L Test pin. (Default pull low).TP[3:0] O H/L Test pins. They must be open.VDDA I H/L Analog power. 6.5V to 13.5V.This information contained herein is the exclusive property of Himax and shall not be distributed, reproduced, or disclosedin whole or in part without prior written permission of Himax.-P.7-January, 2007