<strong>HX8258</strong>-A1200CH TFT LCD Source Driver with TCON6. DC CharacteristicsDATA SHEET V026.1 Absolute Maximum Rating (GND=VSS=0V)ParameterSymbolSpec.Min. Typ. Max.UnitPower supply voltage 1 VCC -0.3 - +7.0 VPower supply voltage 2 VDDA -0.3 - +13.5 VLogic Output Voltage V OUT -0.3 - +7.0 VInput voltage Vin -0.3 - VDDA+0.3 VOperation temperature T OPR -40 - +85 Storage temperature T STG -55 - +125 Note: (1) All of the voltages listed above are with respective to GND=VSS=0V.(2) Device is subject to be damaged permanently if stresses beyond those absolute maximum ratings listedabove.6.2 DC Electrical Characteristics (GND=VSS=0V, TA=25 )Parameter SymbolSpec.Min. Typ. Max.Unit ConditionPower supply voltage VCC 2.7 3.3 3.6 V -Power supply voltage VDDA 6.5 8.4 13.5 V -Low level input voltage V IL 0 - 0.3*VCC V -High level input voltage V IH 0.7*VCC - VCC V -Output low voltage V OL 0 - 0.2*VCC V I OL =400µAOutput high voltage V OH 0.8*VCC - VCC V I OH =-400µAInput level V1~V4, V6 Vref1 0.35*VDDA VDDA-0.1 VGamma correction voltage input,VDDA=8.4VInput level V7~V10, V5 Vref1 VSS+0.1 0.65*VDDA VGamma correction voltage input,VDDA=8.4VInput leakage current I IN -1 - +1 V No pull up or pull down.Output voltagedeviationV VD - ±20 - mV SO1~SO1200DC offset V OS - - ±20 mV SO1~SO1200,V IN =0.1~13.4V,Output leakage current I O -1 - +1 µA SO1~SO1200 at high impedancePull high resistance R H 600 900 1200 kΩRESETB,STB, TEN, CS, SPCK,Pull low resistance R L 600 900 1200 kΩHimax ConfidentialThis information contained herein is the exclusive property of Himax and shall not be distributed, reproduced, or disclosedin whole or in part without prior written permission of Himax.SPEN, SDI, LR, VSETDx[7:0] (x=2,1,0),DEN,RESL[2:0], REV, EDGSL,ENREOP, UD, TEST[1:0],TESTG[1:0]Output current I OH 40 60 - µA SO1~SO1200,V O =9.9V vs. 9V, VDDA=10VOutput current I OL 40 60 - µA SO1~SO1200,Vo=0.1V vs. 1.0V, VDDA=10VAnalog operatingcurrentI DD - 10 - mAFcph=33.3MHz, Parallel RGB,Fhs=32kHz, Black pattern,VDDA=8.4V,Vcc=3.3V, RL=2k, CL=60pFDigital operating current I CC - 4.4 - mAFcph=33.3MHz, Parallel RGB,Fhs=32kHz, Black pattern,VDDA=8.4V,Vcc=3.3V, RL=2k, CL=60pFAnalog standby current I VDDA - - 200 µA All LCD outputs are High-Z.Digital standby current I VCC - - 800 µAAll inputs are stopped andoutputs are High-Z.-P.37-January, 2007
<strong>HX8258</strong>-A1200CH TFT LCD Source Driver with TCON7. AC CharacteristicsDATA SHEET V027.1 Input signal characteristics7.1.1 AC Electrical CharacteristicsPARAMETER SymbolSpec.Min. Typ. Max.UnitHS setup time T hst 6 - - nsHS hold time T hhd 6 - - nsVS setup time T vst 6 - - nsVS hold time T vhd 6 - - nsData setup time T dsu 6 - - nsData hold time T dhd 6 - - nsDEN setup time T esu 6 - - nsSource output settling time T ST - - 15 µsSource output loading R R SL - 2 - kΩSource output loading C C SL - 60 - pFPOL output delay time T DP - - 40 nsHimax ConfidentialThis information contained herein is the exclusive property of Himax and shall not be distributed, reproduced, or disclosedin whole or in part without prior written permission of Himax.-P.38-January, 2007