Wind Sensor Interface - Somfy

LONWORKS ®Wind Sensor InterfaceOut- LONWORKS network in free topology- test mode LED- wind LED:turned on when actual value is higher than thethreshold- service pin LEDThis LPT-10 device interfaces a LONWORKS networkand a wind sensor. It transmits the wind speedvalue and a wind speed threshold on the network.Transmission conditions can be configured bysoftware. Threshold can be chosen between 15values (in km/h): 10-15-20-25-30-35-40-45-50-55-60-65-70-75-80. These values can be changed bysoftware. The 16 th possible threshold setting can beused to switch the devices it is bound to into a testmode.The device can be installed by using the SOMFYintuitive installation process, or with usual installationsoftwares.Software includes a single functional object:Wind Sensor Object- node request and node status- wind speed value- wind speed threshold- test mode- transmission conditions of wind speed value andwind speed threshold- 15 threshold values settingsHardware Inputs/OutputsIn- LONWORKS network in free topology- a SOMFY wind sensor- 16-position selector for threshold- service pin buttonTechnical specificationsHousingprotection indexDIN rail mounting35 mm widthIP20Temperature working range + 5 °C to + 45 °Cstorage range - 20 °C to + 70 °CRate of relativehumidity 90% maximum @ 25 °CPower supplyfrom the networkClass II power supply onlyCurrentconsumption primary 15 mAsecondary 70 mALONWORKS topology free topologynetwork transceiver LPT -10data rate 78 kb/sNeuron ® chip 3150 ® @ 5 MHzCompliant torequirements- Electromagneticcompatibility EN 50081-1, EN 50082-1Connectionsnetworkwind sensor2 screw type terminals2 x 2 mm 2 each2 screw type terminals2 x 2 mm 2 eachReference EBBT 930150IC. 03.00.02.095Any alterations are due to technical development and are therefor non-binding© by SOMFY GmbH Rottenburg

LONWORKS ®Wind Sensor InterfaceWiring diagramWind Sensor InterfaceIC. 03.00.02.096Any alterations are due to technical development and are therefor non-binding© by SOMFY GmbH Rottenburg