Edge 540 Manual - Hangar 9

Section 14: Installing the RadioCONTINUEDStep 5. Remove the servos and drill the 12 holes using a1/16'' drill bit. Remount the servos and screw in the mountingscrews provided with the servos.Note: We wrapped the battery in foam and attached it to theplywood above the fuel tank directly behind thefirewall platform using Velcro ® . For the receiver, weused a J-TEC Pillow Pack, attached Velcro to theplywood floor behind the fuel tank next to the throttleservo, and also attached the receiver Pillow Pack tothe floor using velcro.Step 7. Route the antenna back through the fuselage using anantenna tube (not included), or route it out the side of thefuselage, back toward the tail. Install the switch to the left side ofthe fuselage under the wing, as shown below.Note: Trial fit the switch inside the fuselage to make sure youhave proper clearance.Step 6. Use radio packing foam (available at your local hobbyshop) when you install the receiver and battery pack. There isample room for the receiver and battery in the forward part of thefuselage, in the area above and behind the fuel tank. Wrap thebattery and receiver in foam and install them into the fuselage.Receiver InstallationReceiver Battery Installation33