You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Section 2: Joining the Wing HalvesCONTINUEDStep 14. Locate the yellow and blue center trim tape. Apply aportion to the center of the top and bottom of the wing centerafter the epoxy has cured from Step 13.Step 11. Allow the wing center joint to completely cure, thenremove the masking tape.Step 12. You can mount the two yellow-covered plywood rearwing bolt plates next.Note: The covering will have to be trimmed away fromthe area of the top of the wing so the pieces can beepoxied to the wing. Use care not to cut into the woodstructure of the wing.Trial fit the pieces, marking their location. Use a sharp hobbyknife to trim away the covering over the bolt holes..Step 13. Mix 1/4 ounce of 6-minute epoxy and epoxy the wingbolt plates to the top of the wing. The wing bolt plate holes willbe drilled out later.11
Change language