XR1045 Operation Manual - Xtreme Manufacturing

XR1045Operator Cab WarningDO NOT adjust the seat or seat belt whilethe forklift is moving. Keep both hands onthe wheel while the forklift is moving toprevent loss of forklift control which couldresult in death or serious injury.Before starting the engine, adjust the seat for position andcomfort (refer to the Operator Seat section of this manual)and then adjust the seat belt as follows:1. Grasp the free end of the seat belt (located on the leftside of the seat) and make sure the belt webbing isnot twisted or entangled in any portion of the seatassembly.2. Pull the retractable seat belt across your lap. Positionthe seat belt as low on your body as possible.3. Insert the latch plate into the buckle (on the right sideof the seat) until a “click” is heard.4. Make sure seat belt retracts snugly across your lap.Rear View MirrorsTwo (2) adjustable rear view mirrors are provided to aidthe operator’s rear vision. One (1) rear-view mirror ismounted on the upper left of the operator’s cab.Figure 6-15. Frame Mounted Mirror.Controls and IndicatorsTravel Select LeverThe travel select lever has three (3) positions:FORWARD, NEUTRAL, and REVERSE, which change thedirection of travel.PositionPurposeTable 6. Travel Select LeverF Forward UP Position (Away from the operator).N Neutral CENTER Position.R Reverse DOWN Position (Toward the operator).Figure 6-14. Cab-Mounted Mirror.One (1) rear-view mirror is mounted on the frame.Figure 6-16. Travel Select Lever.The travel select lever automatically locks when it is in theNEUTRAL position. The operator must raise and movethe travel select lever when changing to the FORWARD orREVERSE position.NOTE: The travel select lever must be in theNEUTRAL position to start the reach forklift.NOTE: The back-up alarm automatically sounds when thetravel select lever is in the REVERSE position.For information call (800) 497-1704 Page 37