Fellowes Powershred Micro Cut Shredder MS-470Ci Manual

MS-470CMS-470CMS-470CA.B.C.D.E.F.H.G.J.KEYA. SafeSense ® TechnologyB. Paper entryC. CD entryD. DoorE. Basket - paper (inside)F. Basket - CD (inside)G. See safety instructionsH. Disconnect power switchI. CastersJ. Control Panel and LEDs1. Reverse2. ON/OFF3. Forward4. Bin full5. Door openENGLISHModel MS-470Ci6. Remove paper7. Sheet capacity indicator8. SafeSense ® indicator (yellow)9. Auto buttonJAM PROOF SYSTEM OPERATION*Eliminates frustrating jams by preventing overloads and powering through misfed paper.1 Advanced Jam Prevention- Electronically2 3measures paper thickness to prevent paper jams:Up to RED: Too manysheets have been inserted.Up to YELLOW: Productivityis optimized.Remove several sheets untilindicator is below red.Continue 100% JamProof ShreddingI.CAPABILITIESWill shred: Paper, credit cards, CD/DVDs, staples and standard paper clipsWill not shred: Adhesive labels, continuous form paper, transparencies, newspaper,cardboard, large paper clips, laminates, file folders, X-rays or plastic other than noted abovePaper/Card shred size:Micro-Cut....................................................... 5/64 inches x 15/32 inches (2mm x 12mm)CD shred size:Strip-Cut.......................................................................................... 25/64 inches (10mm)Advanced product featuresMaximum:Sheets per pass............................................................................................................ 12*CDs/Cards per pass........................................................................................................ 1*Paper entry width........................................................................... 9 1/2 inches (240mm)CD entry width ........................................................................... 5 13/64 inches (132mm)* 8.5 inches x 11 inches, 20lb., (75g) paper at 120V, 60 Hz, 6Amps; heavier paper, humidity orother .than rated voltage may reduce capacity. Recommended daily usage rates: 4,000 sheets perday; 200 credit cards; 10 CDs; 5 paper clipsFellowes SafeSense ® shredders are designed to be operated in home and office environments rangingbetween 50 – 80 degrees Fahrenheit (10 – 26 degrees Celsius) and 40 – 80% relative humidity.*100% Jam Proof when used in accordance with user manualSLEEP MODEWHEN IN SLEEP MODEIf a misfeedoccurs:Up to GREEN: More sheetscan be added.1 23All indicators light up andshredder pauses for 3-6 secondsWait for flashing to stop after automatic correctionis complete. Regular shredding will resume.SAFESENSE ® TECHNOLOGY OPERATIONSET-UP AND TESTING1 2If illuminates after paper has beenreversed, press reverse and remove paper.Otherwise, regular shredding will resume.3 4AUTO AUTO AUTO AUTOAUTO AUTOJam Proof SystemEliminates frustrating jamsby preventing overloadsand powering throughmisfed paper.Patented SafeSense ®TechnologyStops shredder immediatelywhen hands are too close tothe paper entry.Sleep ModeEnergy saving featureshuts down automaticallyafter 2 minutes of noshredding activityMicroShred TechnologyMicroShred cut providesmaximum security by shreddingpaper into over 2,513 particlesper 8 1/2" x 11" mm sheet.In sleep modeTo get out of sleep modetouch control panelBASIC PRODUCT MAINTENANCE AND TROUBLESHOOTINGorinsert paperTurn the shredder ON( ) to activate SafeSense ® Touch test area andlook for the SafeSense ®indicator to illuminateSafeSense ® is active andworking properlyIf hand is held on SafeSense ®area more than 2 secondsShredder will shut off151515IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!• Keep away from children and pets. Keep hands away from paperentry. Always set to off or unplug when not in use.• Keep foreign objects – gloves, jewelry, clothing, hair, etc. – awayfrom shredder openings. If object enters top opening, switch toReverse ( ) to back out object.• Never use aerosol products, petroleum based lubricants or other flammableproducts on or near shredder. Do not use canned air on shredder.• Do not use if damaged or defective. Do not disassemble shredder. Donot place near or over heat source or water.BASIC SHREDDING OPERATION• This shredder has a Disconnect Power Switch (H) that must be in the ON (I)position to operate shredder. In case of emergency, move switch to OFF (O)position. This action will stop shredder immediately.• Avoid touching exposed cutting blades under shredder head.• Use only designated entry for shredding CDs• Keep finger away from CD hole when shredding.• Do not put foreign objects in paper entry.• The grounded socket-outlet shall be installed near the equipment and shall beeasily accessible.OILING SHREDDERAll micro-cut shredders require oil for peak performance. If not oiled, amachine may experience diminished sheet capacity, intrusive noise whenshredding and could ultimately stop running. To avoid these problems, werecommend you oil your shredder each time you empty your waste bin.FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE1AUTOTurn off and unplugshredderAUTO2*Apply oil across entry3Press and hold reverse( ) 2-3 secondsCleaning Auto-Start Infrared SensorsPaper detection sensors are designed for maintenance free operation. However, on rare occasions the sensorsmay become blocked by paper dust causing the motor to run even if there is no paper present(Note: two paper detection sensors are located in the center of the paper entry).TO CLEAN THE SENSORS1Turn off and unplugshredder2 34AUTO AUTO AUTOLocate Auto-startinfared sensorDip cotton swab inrubbing alcoholMS-470CUsing cotton swab, wipeaway any contaminationfrom the paper sensorsPAPER/CARD OR CD*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 352501234 56PREVENTIVE MAINTENANCE AND MISCELLANEOUS TROUBLESHOOTING2Plug in and putdisconnect powerswitch in ON (I) positionAUTOPress ( ) ON toactivateFeed paper/cardstraight into paperentry and releaseHold CD at edge,feed into CDentry and releasewww.fellowes.com features an extensive on-line support section with a number of self-service optionsAUTOWhen finishedshredding setto OFF ( )orDo nothing andshredder will goautomatically tosleep mode• Self Cleaning Cycle: Shredder periodically cycles in forward and reverse lasting 3-6 seconds. 15• Empty wastebasket when bin full indicator lights up.• Shredder won’t run if the door is open, or bin needs to be emptied. Bin must be in machine, with door closed, in order for machine to operate properly.• Maintenance is an important part of protecting your investment. Don’t forget our oil (35250) and shredder bags (36054).Go to Support Section at www.fellowes.com or see back page of manual for useful telephone numbers.3