Load Sharing Module - Home Mega Global Solution

Manual 26011Load Sharing Module39. Measure the load signal voltage between terminals 22 and 23 and record thisvoltage.40. Shut down the generator set.41. Remove the phase “B” CT wires from the CT input terminals and connect thewires to the pair of terminals, in the same polarity, that produced the mostpositive load signal voltage.42. Untape and disconnect the Phase “C” CT wires. Connect the phase “C” CTwires to remaining pair of CT input terminals on the Load Sharing Module.43. Start the generator set and apply full load.44. Measure the load signal voltage at terminals 22 and 23 and record thisvoltage.45. Shut the generator set down and reverse the phase “C” wires on the CT inputterminals.46. Start the engine and apply full load.47. Measure the load signal voltage between terminals 22 and 23 and record thisvoltage.48. Shut down the generator set.49. Remove the phase “C” CT wires from the CT input terminals and connect thewires to the pair of terminals, in the same polarity that produced the mostpositive load signal voltage.50. Label each wire with the designation of the terminal to which it is nowconnected. Be sure and remove the original designations to avoid futureconfusion.Load Gain AdjustmentFor this procedure, the generator set must be running isochronously, notparalleled, and with a power factor greater than 0.8.1. Start the generator set and run at full load.2. Measure the load signal voltage and adjust the LOAD GAIN potentiometerfor 6 ± 0.1 Vdc.If the load signal voltage cannot be raised to 6 volts, and the phasing has beenchecked and is correct, it will be necessary to use a lower load signal voltage. Setthe full load signal voltages of all generator sets in the system to the same voltage.Woodward 19