Load Sharing Module - Home Mega Global Solution

Load Sharing Module Manual 2601120. Start the engine and apply full load.21. Measure the load signal voltage between terminals 22 and 23 and record thisvoltage.22. Shut the generator set down and reverse the phase “A” wires on terminals 8and 9.23. Start the engine and apply full load.24. Measure the load signal voltage between terminals 22 and 23 and record thisvoltage.25. Shut down the generator set.26. Remove the phase “A” CT wires from terminal 8 and 9 and connect the wiresto the pair of terminals, in the same polarity, that produced the most positiveload signal voltage.27. Untape and disconnect the Phase “B” CT wires. Connect the phase “B” CTwires to one pair of the two remaining CT input terminals on the LoadSharing Module.28. Start the generator set and apply full load.29. Measure the load signal voltage at terminals 22 and 23 and record thisvoltage.30. Shut the generator set down and reverse the phase “B” wires on the CT inputterminals.31. Start the engine and apply full load.32. Measure the load signal voltage between terminals 22 and 23 and record thisvoltage.33. Shut down the generator set.34. Remove the phase “B” CT wires from the terminals they are connected to andconnect them to the remaining pair of CT input terminals on the LoadSharing Module.35. Start the generator set and apply full load.36. Measure the load signal at terminals 22 and 23 and record this voltage.37. Shut the generator set down and reverse the phase “B” wires on the CT inputterminals.38. Start the engine and apply full load.18 Woodward