Load Sharing Module - Home Mega Global Solution

Manual 26011Load Sharing Module4. Disconnect the phase “C” CT wires from terminals 8 and 9 and connect thesetwo wires together. Use a small screw and nut and tape the connection.5. Connect the two wires from the phase “A” CT to phase “A” input terminals 4and 5.!WARNINGTO PROTECT AGAINST POSSIBLE PERSONAL INJURY, LOSS OFLIFE, and/or PROPERTY DAMAGE EACH TIME you START the engine,turbine, or other type of prime mover, BE PREPARED TO MAKE ANEMERGENCY SHUTDOWN to protect against runaway or overspeedshould the mechanical-hydraulic governor(s), or electric control(s),the actuator(s), fuel control(s), the driving mechanism(s), thelinkage(s), or the control devices fail.6. Start the engine and apply full load.7. Measure the load signal voltage between terminals 22 and 23 and record thisvoltage.8. Shut the generator set down and reverse the phase “A” wires on terminals 4and 5.9. Start the engine and apply full load.10. Measure the load signal voltage between terminals 22 and 23 and record thisvoltage.11. Shut the generator set down.12. Remove the phase “A” CT wires from terminal 4 and 5 and connect the phase“A” CT wires to the phase “B” input terminals 6 and 7.13. Start the engine and apply full load.14. Measure the load signal voltage between terminals 22 and 23 and record thisvoltage.15. Shut the generator set down and reverse the phase “A” CT wires on terminals6 and 7.16. Start the engine and apply full load.17. Measure the load signal voltage between terminals 22 and 23 and record thisvoltage.18. Shut down the generator set.19. Remove the phase “A” CT wires from terminal 6 and 7 and connect the phase“A” CT wires to the phase “C” input terminals 8 and 9.Woodward 17