Transitional Specification - OEC Business Interiors

Corner WorksurfacesCorner WorksurfacesCorner worksurfaces areused to provide a transitionwhen forming a U- or L-shapedworkstation. To form a U-shapedworkstation, the use of a bridgeis required to connect the desk,credenza, or bullet table to thework surface. To form an L-shaped workstation, the use oftwo returns are required. Cornerworksurface must be connectedto adjacent returns, credenzas orbridges.cSpecifying, page 352Back panels reach full tothe floor.End panel is 10"D andcorresponds to the clearaccess end panel depth onadjacent worksurfaces toprovide a uniformappearance.Leveling glides allowinstallation on uneven floors.Actual DimensionsDepth 25" or 30"Width 42" or 45"Worksurface height 29 3 ⁄4"Worksurface thickness 1 1 ⁄2"Front edge 14 5 ⁄8", 24 5 ⁄8", or 28 7 ⁄8"Back panel height 27 5 ⁄8". Leveling glide range 1 1 ⁄2"Angled corner allowscords and cables to passbehind the worksurface.Worksurface is availablein wood only.Radius edge is locatedon all sides..Product DetailsCenter drawer is notavailable on corner worksurfaces.Use adjacentdesk or credenza for lockingstorage.Wiring & CablingGrommet is available,factory installed, to allowcords and cables to passthrough the worksurface.cPage 317A variety of products areavailable to manage cordsand cables under theworksurface.cSee Series 9000 SystemsFurniture SpecificationGuide..Surface MaterialsCorner worksurface• Wood (standard)• Customiz stain (optionon wood)• Full-fill finish (option onworksurface only)Grommet• Black plasticApplication TopicsIf adjacent desks orcredenzas require a clearaccess end panel, you mustorder a shell, specify theappropriate clear accessend panels and addpedestals in the field..Series 9000Transitional Specification Guide 309