Transitional Specification - OEC Business Interiors

Worksurfaces and Supports Used in Off-Module PositionsTip: Always use on-moduleworksurface supports in allvertical panel upright slotpositions to provide forwardtip support. Off-moduleworksurfaces are supportedwith a combination of offmoduleworksurfaces andon-module worksurfacesupports.Cantilever, which is nonhanded,attaches to adjacentframe in on-modulepositions to support oneworksurface or two worksurfacesin line.Opening in cantilever facilitatesthe routing and managementof cables beneaththe worksurface.Worksurface has a woodcore with a laminate surfaceand a wood core with woodveneer surface.Off-module pedestalsare available to supportworksurfaces in off-modulepositions. You must orderan off-module pedestalto use in an off-moduleposition.Tip: Worksurfaces canhang off an on-moduleworksurface support by amaximum of 6" before anoff-module end panel, offmodulepedestal, or offmoduleworksurface bracketand freestanding leg mustbe used.Actual DimensionsThickness 1 1 ⁄4"Height 28 1 ⁄2". Depth 23 1 ⁄2" or 29 1 ⁄2"scale 50End support bracket,ordered separately, supportsthe back corner ofcorner, extended corner,extended corner cove, andworksurfaces. Brackets areused in the vertical paneluprights which are for onmodulepositions only.Off-module worksurfacebracket is usedwhere two worksurfacesjoin in off-module positions.Bracket can also be usedto support the front cornerof a worksurface on an offmodulefin panel.Cantilever can only beused in on-module verticalpanel uprights.Off-module tie plateis ordered separately andis required to make connectionto adjacent worksurfacesand used inconjunction with off-moduleworksurface brackets.Off-module end panelsare available to support theend of a worksurface in offmodulepositions. You mustorder an off-module endpanel to use in off-modulepositions..132 Transitional Specification Guide