Transitional Specification - OEC Business Interiors

Straight, Corner,Extended Corner, andExtended Corner CoveWorksurfaces.Field-installed centerdrawer can be installedbeneath curvilinear worksurfaceswherever spacepermits—requires 19 1 ⁄2"D x21"W.Adjustable-heightcantilevers are availableto support corner andstraight worksurfaces from24 1 ⁄2"H to 34 1 ⁄2"H at 1"increments in on-modulepositions only.Tip: Requires a thirdadjustable-height cantileverto support rear corner ofcorner worksurface. Alsocannot be used in combinationwith desk-height cablemanagement tray. Maximumspan between adjustableheightcantilevers is 48".Adjacent worksurfacesmust be the same height toconnect. Do not combinecorner or straight worksurfacesthat are supported byadjustable-height cantileverswith worksurfacesthat are column supported.ConnectionsWorksurfaces arestandard without supports.Worksurface supportsinclude:• Pedestal• Off-module pedestal• End panel• Off-module end panel• Cantilever• Shared cantilever• End-of-run cantilever• End support brackets• Off-module worksurfacebracket• Off-module tie plate48"W or wider worksurfacescan spantwo frames.On-module Off-moduleEnd panels are availablein left- and right-hand versionsto support either endof a worksurface. A bracketis included with the endpanel to connect it to theframe. End panels are usedin on-module or off-modulepositions. End panels canbe converted in the field tostandard or off-module endpanels by ordering a panelpackage from Service Parts.Cantilever has a nonhandedflange that allowsit to support either theright- or left-hand side ofa worksurface in on-modulepositions only...Two cantilevers canbe used side by side in onmodulepositions to supportstraight and corner worksurfacesthat are joined.End-of-run cantileveris used to support the endof a corner worksurface inon-module positions. Cantileversare for use in onmodulepositions only.TwoOne SharedShared cantilevers canonly be used to supportworksurfaces with their owncolumn supports—bubblevisitor, jetty, bubble jetty,and visitor worksurfaces.Use two adjacent cantileversto support straightor corner worksurfaces thatare joined..Off-module worksurfacebracket is used off-modulewhere two worksurfacesjoin in off-module positions.Bracket can also be used tosupport the front of a worksurfaceon an off-module finpanel.Tip: Off-module worksurfacebracket must be used withon-module supports.End support bracket isused to support the backcorner of any corner worksurfaceand can be used tosupport the ends of rectangularor corner worksurfaceswhen they are wrapped byframes. Bracket is used inon-module positions only.Tip: End support bracketpairs are ordered separately.Make sure you specify anadequate supply.Off-module tie plateis included to make connectionto adjacent worksurfacesand is used inconjunction with off-moduleworksurface brackets..Wiring & CablingClear space at the backof worksurface allows cordsand cables to pass over atany point. Cable scallopsprovide space for plugs topass over the back edgeof the worksurface.Cable managementdevices are available tohelp manage conventionaland fiber-optic cablesbeneath the worksurface..MontageTransitional Specification Guide cStraight, Corner, Extended Corner, and Extended Corner Cover Worksurfaces, continued 123