Owner's Manual 2010 TE/TC/TXC 310/450/510 - Husqvarna
Owner's Manual 2010 TE/TC/TXC 310/450/510 - Husqvarna
Owner's Manual 2010 TE/TC/TXC 310/450/510 - Husqvarna
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
FRONT BRAKING SYS<strong>TE</strong>M BLEEDING (SMR)The braking system must be bled after the fluid replacementor when, due to air in the circuit, the lever stroke is longand spongy.Regarding the front braking system, first proceed to bleed theupper braking system control (bleeding valve 1), thenthe brake caliper (bleeding valve 1A).In both cases, proceed as follows:- Remove the rubber cap on the bleeding valve (1) or (1A).- Attach a clear plastic hose to the bleeding valve on the brakecaliper and turn the other end of the hose into a container(make sure that the end of the hose is submerged in brakefluid during the entire bleeding operation).- Remove fluid reservoir cap (2), the rubber and fill the reservoirwith fresh brake fluid.- Open the bleeding valve and pump with brake lever severaltimes until the fluid, clear and without bubbles, comes out ofthe hose: now close the bleeding valve.1ASMRSMR64
Change language