Owner's Manual 2010 TE/TC/TXC 310/450/510 - Husqvarna

REMOVING THE REAR WHEELUnscrew the nut (1) of the wheel pin (3) and extract it. It is notnecessary to unloose the chain adjusters (2); in this way, thechain tension will remain unchanged after the reassembly.Extract the complete rear wheel, by taking care of the spacerslocated at the hub sides.To reassemble, reverse the above procedure remembering toinsert the disc into the caliper.NOTESDo not operate the rear brake pedal when the wheel has beenremoved; this causes the caliper piston to move outwards.After removal, lay down the wheel with brake disc on top.After reassembly, pump the brake control pedal until the padsare against the brake disc.1254