Owner's Manual 2010 TE/TC/TXC 310/450/510 - Husqvarna
Owner's Manual 2010 TE/TC/TXC 310/450/510 - Husqvarna
Owner's Manual 2010 TE/TC/TXC 310/450/510 - Husqvarna
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
AIR FIL<strong>TE</strong>R CHECK (<strong>TC</strong>-<strong>TXC</strong>)Turn rear pin (1) counterclockwise, remove the saddle from thefront afstening screw.<strong>TXC</strong>: Take out the battery (A) and place it sideways on the vehicle.Remove screw (3) and the filter (4). Separate filter (5) fromframe (6).1AIR FIL<strong>TE</strong>R AND CLEANINGWash the filter with a specific detergent (AGIP” Filter cleanfoam air detergent fluid” or similar) then dry it fully (wash filterwith gasoline only in case of necessity).Plunge the filter in special oil for filters (AGIP "Foam air filterprotection oil" or similar), then wring it to drain superfluousoil.CAUTION*: Do not use gasoline or a lowflash-point solvent to clean the element. Afire or explosion could result.CAUTION*: Clean the element in a well ventilatedarea, and do not allow sparks orflames anywhere near the working area.ASSEMBLYTo ensure tight fit, slightly (C) grease filter edge on side facingfilter housing.While re-inserting the filter into its housing, make surs thatpiece (A) is turned upwards and edge (B) is on the left lowerside of the filter case. Reassemble the parts previously removed(battery: connect the positive cable first).CAUTION*: If the element assembly is notinstalled correctly, dirt and dust may enterand the engine resulting in rapid wear ofthe piston rings and cylinder.UPPER SIDE<strong>TC</strong>-<strong>TXC</strong>LEFT SIDEA463534
Change language