Owner's Manual 2010 TE/TC/TXC 310/450/510 - Husqvarna
Owner's Manual 2010 TE/TC/TXC 310/450/510 - Husqvarna
Owner's Manual 2010 TE/TC/TXC 310/450/510 - Husqvarna
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
ADJUSTING THE CARBURETTOR (<strong>TC</strong>-<strong>TXC</strong>)Adjust the carburettor with warm engine and with the throttlein closed position.Work as follows:- Turn slow running adjusting screw (1) on the left side of thebike, , until the engine is turning over at fairly high rpm(turn the screw clockwise to increase the rpm, and anticlockwiseto descrease the rpm).- Turn adjusting screw (2) clockwise until the fully closed positionis reached then turn back 1,5 turns (<strong>TXC</strong> 250) 2,0 turns(<strong>450</strong>-<strong>510</strong>)- progressively loosen adjusting screw (1) to obtain the slowrunning required.ADJUSTING THE IDLE (<strong>TE</strong>-SMR)Adjust the carburetor with warm engine and with the throttlecontrol in closed position. Proceed as follows:- turn the idle speed adjustment screw (3) on the throttlebody, located on the right side of the vehicle, until the idlespeed of 1600 RPM is reached (turn clockwise to increasethe speed and anti-clockwise to reduce the speed).ADJUSTING THE IDLE (<strong>TC</strong>-<strong>TXC</strong>)Adjust the carburetor with warm engine and with the throttlecontrol in closed position. Proceed as follows:- Turn slow running adjusting screw (1) on the left side of thebike, near the fuel cock (turn the screw clockwise to increasethe rpm, and anticlockwise to descrease the rpm).332
Change language