Owner's Manual 2010 TE/TC/TXC 310/450/510 - Husqvarna

THROTTLE CABLE ADJUSTMENTTo check the correct adjustment of the throttle operate as follows:- remove the upper rubber cap (1);- by moving cable (2) back and forth check for 2 mm. clearance;- should the clearance be incorrect, unblock the counter ringnut(3) and turn the adjusting screw (4) (by unscrewing it,the clearance is reduced, while by screwing screw (4) it isincreased);- tighten the counter ring-nut again (3).NOTEIn case of throttle control cables (1) and (2) replacement it isnecessary to respect, during reassembly, the measure Á(10mm/0.4 in.), as shown in the picture. Then reassembleguard cover (B) using screw (3) and adjust throttle controlcables on handlebar as described at side.To replace throttle control cables, first remove tha fuel tank.ENWARNING*: Operation with damaged throttlecable could result in an unsafe ridingcondition.WARNING*: Exhaust gas contains poisonouscarbon monoxide gas. Never run the enginein a closed area or in a confined area.31