Owner's Manual 2010 TE/TC/TXC 310/450/510 - Husqvarna

CHECKING THE OIL LEVELKeeping the motorbike level and in a vertical position, check theoil level through the inspection (1) window on the rightcrankcase. Make sure the level is in between the MIN and MAXnotches.To fill up, remove the filler cap (2).Note*: Have this operation made withwarmed-up engine.WARNING*: Be careful not to touch hot engineoil.ENGINE OIL REPLACEMENT AND BAG FILTERS-FIL-TER CARTRIDGE CLEANING OR REPLACEMENTWARNING*: Be careful not to touch hot engineoil.Drain the oil with WARM ENGINE; proceed as follows:- remove oil filler cap (2);- remove the engine guard (A)- place an oil drain pan under the engine block- remove the oil drain cap (3)- drain the used oil completely then clean the magneto on thecap;- remove the three filters (5), (6) and (7) on the L.H. side ofthe engine, check O-Rings for wear then clean filters with fuel;reassemble using the reverse procedure;- in order to replace the filter cartridge (4), unscrew the threefastening screws then the filter cartridge cover;- after filters replacement, reassemble the drain cap (3), theengine guard (A) then pour the recommended oil quantity.1MAXMIN2A23 428