Owner's Manual 2010 TE/TC/TXC 310/450/510 - Husqvarna
Owner's Manual 2010 TE/TC/TXC 310/450/510 - Husqvarna Owner's Manual 2010 TE/TC/TXC 310/450/510 - Husqvarna
5) pull the lever (5) and lower further, by a limited stroke, thepedal until the abovementioned resistance is overcome(surpassing of T.D.C.);6) at this point, release the lever (5) and the pedal (4); 7) in the case of COLD STARTING, completely rotate the throttle(6) twice (in the case of warm starting DO NOT carry outthis operation);TC-TXCTC-TXC24TC-TXC4
8) COMPLETELY lower the pedal (4) until the engine starts.WARM STARTING: BEFORE MOTORCYCLESTARTING, PRESS RED CHOKE KNOB (3) ONCARBURETOR TOWARD THE INSIDE IN ORDERTO DEACTIVATE THE STARTING DEVICE.In case the engine does not start, repeat this procedure.IMPORTANT NOTE IN CASE OF COLD STARTS ATLOW TEMPERATURESIt is recommended to briefly warm-up the engine at idle until,after having disengaged the starter, there is a normal responsefrom the engine when opening the throttle.In this way the oil can reach all the surfaces needing lubricationand the coolant will reach the necessary temperature forcorrect engine function.Avoid overheating the engine.IMPORTANTNever accelerate the engine after a cold start.WARNING*: Exhaust contains poisonous carbonmonoxide gas. Never run the engine ina closed garage or in a confined area.In the case of using a kick-starter, followcarefully the instructions on the page 23keep in mind the undermentioned note.Kick start pedalWARNING*: This high performance motorcyclecan some times «kick back» stronglywhen you are starting it.Do not attempt to start this motorcycle unlessyou are wearing high top heavy sidedriding boots. You could seriously hurt youleg if the kickstarter kicked back and yourfoot slipped.ENTC-TXC4 325
- Page 1 and 2: ENGLISH1
- Page 3 and 4: IMPORTANTThe reference for recognit
- Page 5 and 6: VEHICLE IDENTIFICATION NUMBER (V.I.
- Page 7 and 8: Control location1. Front brake leve
- Page 9 and 10: FINAL RATIOS1st gear (TE 310) . . .
- Page 11 and 12: CONTROLSFUEL COCK (TC-TXC)The left-
- Page 13 and 14: CARBURETOR CHOKE (TC-TXC)The starte
- Page 15 and 16: 2- SPEED / CLOCK (figure 2)- SPEED:
- Page 17 and 18: THROTTLE CONTROLThe throttle knob (
- Page 19 and 20: REAR BRAKE CONTROLThe rear brake co
- Page 21 and 22: ENGINE START (TE-SMR)With cold engi
- Page 23: ENGINE START (TC-TXC)Proceed as fol
- Page 27 and 28: STOPPING THE MOTORCYCLE AND THE ENG
- Page 29 and 30: COOLANT LEVEL CHECKCheck level (1)
- Page 31 and 32: THROTTLE CABLE ADJUSTMENTTo check t
- Page 33 and 34: SPARK PLUG CHECKUse NGK CR8EB spark
- Page 35 and 36: AIR FILTER CHECK (TE-SMR)Turn rear
- Page 37 and 38: ADJUSTMENT OF THE CONTROL LEVER AND
- Page 39 and 40: CHECKING THE FLUID LEVELThe level (
- Page 41 and 42: ADJUSTING THE SUSPENSIONS ACCORDING
- Page 43 and 44: OIL FORK LEVELFor the regular fork
- Page 45 and 46: OIL FORK LEVELFor the regular fork
- Page 47 and 48: ADJUSTING THE SHOCK ABSORBERThe rea
- Page 49 and 50: CHAIN ADJUSTMENT (Fig. A)Chain shou
- Page 51 and 52: 2 - Check that the chain is neither
- Page 53 and 54: REASSEMBLING THE FRONT WHEELFit the
- Page 55 and 56: TIRESCare should be taken to keep t
- Page 57 and 58: PADS CLEANINGBe careful that no dis
- Page 59 and 60: DISC CLEANINGPoor braking can also
- Page 61 and 62: - Pump with brake lever (3) or brak
- Page 63 and 64: - Remove fluid reservoir cap (2), t
- Page 65 and 66: - Restore the brake fluid level (A)
- Page 67 and 68: EXHAUST MUFFLER (TC-TE-TXC)The muff
- Page 69 and 70: OVERHAULING THE WHEELSDEFORMATION R
- Page 71 and 72: - Two fuses (9) 15A and one (13) 20
- Page 73 and 74: - Spark plug (5) on the R.H. side o
8) COMPLE<strong>TE</strong>LY lower the pedal (4) until the engine starts.WARM STARTING: BEFORE MOTORCYCLESTARTING, PRESS RED CHOKE KNOB (3) ONCARBURETOR TOWARD THE INSIDE IN ORDERTO DEACTIVA<strong>TE</strong> THE STARTING DEVICE.In case the engine does not start, repeat this procedure.IMPORTANT NO<strong>TE</strong> IN CASE OF COLD STARTS ATLOW <strong>TE</strong>MPERATURESIt is recommended to briefly warm-up the engine at idle until,after having disengaged the starter, there is a normal responsefrom the engine when opening the throttle.In this way the oil can reach all the surfaces needing lubricationand the coolant will reach the necessary temperature forcorrect engine function.Avoid overheating the engine.IMPORTANTNever accelerate the engine after a cold start.WARNING*: Exhaust contains poisonous carbonmonoxide gas. Never run the engine ina closed garage or in a confined area.In the case of using a kick-starter, followcarefully the instructions on the page 23keep in mind the undermentioned note.Kick start pedalWARNING*: This high performance motorcyclecan some times «kick back» stronglywhen you are starting it.Do not attempt to start this motorcycle unlessyou are wearing high top heavy sidedriding boots. You could seriously hurt youleg if the kickstarter kicked back and yourfoot slipped.EN<strong>TC</strong>-<strong>TXC</strong>4 325