12.07.2015 Views

Owner's Manual 2010 TE/TC/TXC 310/450/510 - Husqvarna

Owner's Manual 2010 TE/TC/TXC 310/450/510 - Husqvarna

Owner's Manual 2010 TE/TC/TXC 310/450/510 - Husqvarna

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

RIDINGBEFORE EVERY RIDE MAKE FOLLOWING CHECKSWARNING!Before each ride, to prevent accidents or failures during ride,make sure to go through following list.1. Check all fluidsA. Engine-transmission oil levelB. fuel levelC. coolant levelMake sure all caps are properly adjusted.WARNING*: Don’t remove radiator capwhen hot!2. Check all controlsA. Throttle handgripB. Clutch leverMake sure cables are not damaged and turn smoothly.3. Check brakesLook for brake fluid leaks and worn hoses. Check for properfunctioning.4. Check suspensionsCompress fork and rear suspensions. Look for oil leaks andensure proper functioning.5. Check wheelsCheck spokes and look for worn bearings.Check rims and tyres.Check tyre pressure.6. Check chain rollers and sprocketsCheck wear on chain rollers and sprocketsEnsure chain is correctly adjusted and lubricated.7. Check air filter and intake systemCheck that air filter is cleanCheck all rubber connections and clamps.8. Check exhaust systemCheck hook up, look for cracksCheck muffler.9. Check torqueA. Spark plug (see page 34).B. General check of torque10. Check steering actionCheck bearing play.11. Check the electric system (<strong>TE</strong>- SMR).Start the engine and check that the front and rear lamps,the stop light, the turn signals the cluster warning lightsand the horn are working correctly.WARNING*: Failure to perform these checksevery day before you ride may result inserous damage or a severe accident.RUNNING INBefore using the motorcycle for sporting activities run in theengine for two hours at least to increase the life and the performanceof the engine.During the first half-hour of driving we advise keeping a lowspeed and avoiding sudden accelerations. Never open thethrottle fully.Change the oil and carry out all the necessary maintenance operations.After the first half-hour of driving, lightly increase therev number, but never run the engine at full throttle. Neverkeep low speeds when the high gears are inserted.Slowly drive the motorcycle for two hours before using it forsporting activities.CHECKS WHILE RUNNING IN- SPOKE <strong>TE</strong>NSION OF WHEELS (see page 69);- TIGH<strong>TE</strong>NING OF WHEELS;- FORK PIN TIGH<strong>TE</strong>NING;- CHAIN ADJUSTMENT (see page 49);- S<strong>TE</strong>ERING BEARING PLAY (see page 36);- HANDLEBAR TIGH<strong>TE</strong>NING;- ENGINE GRIP TO FRAME;- SUCTION FITTING GRIP;- HEAD AND CYLINDER NUTS GRIP;OF<strong>TE</strong>N CHECK THE BAT<strong>TE</strong>RY CHARGE CONDITION (see page 78)20

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!