Owner's Manual 2010 TE/TC/TXC 310/450/510 - Husqvarna

REAR BRAKE CONTROLThe rear brake control (1) is placed on the right-hand side ofthe motorcycle. On models TE and SMR as stop switch, duringthe braking action, causes the rear light to come on.GEAR SHIFT CONTROLThe lever (1) is placed on the left-hand side of the engine. Theoperator must release the lever after each gear change to allowit to return to its central position before another gearchange can be made.Neutral position (N) is between first (low) and second gears.First gear is engaged by pushing the lever downwards; all theother gears are engaged, by pushing the lever upwards.The position of the gear shift lever on the shaft can be variedby:- loosening screw;- pulling lever out;- placing lever in new position on the shaft when the operationis over tighten the screw and then tightening the screw.ENCAUTION*: Do not shift gears without disengagingthe clutch and closing the throttle.The engine could be damaged by overspeedand shock.WARNING*: Do not downshift when travelingat a speed that would force the engineto overrev in the next lower gear, or causethe rear wheel to lose traction.N: NeutralN: Neutral11TCTE-SMR-TXC19