Owner's Manual 2010 TE/TC/TXC 310/450/510 - Husqvarna
Owner's Manual 2010 TE/TC/TXC 310/450/510 - Husqvarna Owner's Manual 2010 TE/TC/TXC 310/450/510 - Husqvarna
SIDESTANDA sidestand (1) is supplied with every motorcycle.WARNING*: The stand is designed to supportthe weight of the MOTORCYCLE ONLY.Do not sit on the motorcycle using the standfor support as this could cause structuralfailure to the stand and could cause seriousbodily injury.TC-TXC1Periodically check the side stand (see “Periodical maintenancecard”); check that the springs are not damaged and that theside stand freely moves. If the side stand is noisy, lubricate thefastening pivot (A).FUELRecommended fuel: premium grade unleaded fuel. (R.O.N.98).Note*: Do not continue operation if the enginepings or knocks. The engine will bedamaged and could seize.WARNING*: If "knocking" or "pinging" occurs,try a different brand of gasoline orhigher octane grade.WARNING*: Gasoline is extremelyflammable and can be explosive under certainconditions. Always stop the engine anddo not smoke or allow flames or sparks inthe area where the motorcycle is refueledor gasoline is stored.WARNING*: Do not overfill the tank. Afterrefueling, make sure the tank cap (2) isclosed securely.2121TE-SMRA
CARBURETOR CHOKE (TC-TXC)The starter knob, located on the left side of the carburetor, isused to enrich the mixture during the engine start.Pull out the knob to open the starter, and pull the lever upwardsto close it.The carburetor is equipped with two knobs:COLD START (TE-SMR)For a cold start, the models with a fuel injection engine are fittedwith a black knob (3) located on the left of the throttlebody.Pull the knob outwards to open the starter and push inwards toclose.EN1) BLACK KNOB: COLD start (°)2) RED KNOB: WARM start (°)(°) See page 232113
- Page 1 and 2: ENGLISH1
- Page 3 and 4: IMPORTANTThe reference for recognit
- Page 5 and 6: VEHICLE IDENTIFICATION NUMBER (V.I.
- Page 7 and 8: Control location1. Front brake leve
- Page 9 and 10: FINAL RATIOS1st gear (TE 310) . . .
- Page 11: CONTROLSFUEL COCK (TC-TXC)The left-
- Page 15 and 16: 2- SPEED / CLOCK (figure 2)- SPEED:
- Page 17 and 18: THROTTLE CONTROLThe throttle knob (
- Page 19 and 20: REAR BRAKE CONTROLThe rear brake co
- Page 21 and 22: ENGINE START (TE-SMR)With cold engi
- Page 23 and 24: ENGINE START (TC-TXC)Proceed as fol
- Page 25 and 26: 8) COMPLETELY lower the pedal (4) u
- Page 27 and 28: STOPPING THE MOTORCYCLE AND THE ENG
- Page 29 and 30: COOLANT LEVEL CHECKCheck level (1)
- Page 31 and 32: THROTTLE CABLE ADJUSTMENTTo check t
- Page 33 and 34: SPARK PLUG CHECKUse NGK CR8EB spark
- Page 35 and 36: AIR FILTER CHECK (TE-SMR)Turn rear
- Page 37 and 38: ADJUSTMENT OF THE CONTROL LEVER AND
- Page 39 and 40: CHECKING THE FLUID LEVELThe level (
- Page 41 and 42: ADJUSTING THE SUSPENSIONS ACCORDING
- Page 43 and 44: OIL FORK LEVELFor the regular fork
- Page 45 and 46: OIL FORK LEVELFor the regular fork
- Page 47 and 48: ADJUSTING THE SHOCK ABSORBERThe rea
- Page 49 and 50: CHAIN ADJUSTMENT (Fig. A)Chain shou
- Page 51 and 52: 2 - Check that the chain is neither
- Page 53 and 54: REASSEMBLING THE FRONT WHEELFit the
- Page 55 and 56: TIRESCare should be taken to keep t
- Page 57 and 58: PADS CLEANINGBe careful that no dis
- Page 59 and 60: DISC CLEANINGPoor braking can also
- Page 61 and 62: - Pump with brake lever (3) or brak
CARBURETOR CHOKE (<strong>TC</strong>-<strong>TXC</strong>)The starter knob, located on the left side of the carburetor, isused to enrich the mixture during the engine start.Pull out the knob to open the starter, and pull the lever upwardsto close it.The carburetor is equipped with two knobs:COLD START (<strong>TE</strong>-SMR)For a cold start, the models with a fuel injection engine are fittedwith a black knob (3) located on the left of the throttlebody.Pull the knob outwards to open the starter and push inwards toclose.EN1) BLACK KNOB: COLD start (°)2) RED KNOB: WARM start (°)(°) See page 232113