Owner's Manual 2010 TE/TC/TXC 310/450/510 - Husqvarna
Owner's Manual 2010 TE/TC/TXC 310/450/510 - Husqvarna Owner's Manual 2010 TE/TC/TXC 310/450/510 - Husqvarna
DIMENSION, WEIGHT, CAPACITYWheelbase(TC-TE-TXC) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 58.38 in.(SMR). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 56.89 in.Overall length(TC) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 86.42 in.(TE) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 89.25 in.(SMR) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 85.16 in.(TXC) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 85.94 in.Overall width . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32.30 in.Overall height(TC-TE-TXC) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 50.59 in.(SMR). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 49.21 in.Saddle height(TC). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 38.11 in.(TE-TXC). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 37.91 in.(SMR ) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 36.22 in.Minimum ground clearance(TC-TE-TXC). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11.81 in.(SMR). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9.64 in.Dry weight(TC 450) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . lb. 228.2(TE 310) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . lb. 235.9(TE 450-510) . . . . . . . . . . . . . . . . . . . . . . . . . . . lb. 244.7(SMR 450-510). . . . . . . . . . . . . . . . . . . . . . . . . . lb. 265.7(TXC 450-510) . . . . . . . . . . . . . . . . . . . . . . . . . . . lb 238,1Fuel tank capacity (TE-SMR, 1.58 Imp. Qt./ 1.9 U.S. Qt. reserveincluded) 1.58 Imp. Gall./ 1.9 U.S. GallCoolant capacity . . . . . . . . . . . . . . . . . 2.0÷2.4 Imp. Pints;. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2.3÷2.7 U.S. PintsTransmission oilOil and oil filter replacement .......Imp. Quarts 1.5, U.S. Quarts 1.8Oil replacement .......................Imp. Quarts 1.3, U.S. Quarts 1.6TABLE FOR LUBRICATION, SUPPLIESEngine, gearbox and primary drive lubricating oilCASTROL POWER 1 RACING 10W-50Engine coolantASTROL MOTORCYCLE COOLANTBrake system fluidCASTROL RESPONSE SUPER DOT 4Clutch fluidGrease lubricationFinal drive chain lubricationCASTROL FORK OIL 10WCASTROL LM GREASE 2CASTROL CHAIN LUBE RACINGFront fork oilMarzocchi: CASTROL SYNTHETIC FORK OIL 5W - Kayaba: KHL15-11Oil for rear shock absorberCASTROL SYNTHETIC FORK OIL 5WElectric contact protectionCASTROL METAL PARTS CLEANERFillers for radiatorAREXONS TURAFALLE LIQUIDO10
CONTROLSFUEL COCK (TC-TXC)The left-side tap (2) is a screw tap: screw the ring nut (A) toclose the tap, loosen the ring nut to open the tap.WARNING*: Be careful not to touch the hotengine while operating the fuel valve.A fuel filter is incorporated in the fuel valves. Accumulation ofdirt in the filter will restrict the flow of the fuel to the carburetor.Therefore, the fuel filter should be serviced periodically.1 Loosen the input plug (1) on the fuel tank and close the tap;2 Remove the fuel hose (3) from the carburetor and insert thehose in a vessel;3 Open the tap and drain the fuel out of the tank;4 Remove the fuel valve by removing the screws. Wash the fuelscreen filter in cleaning solvent;5 Reassemble the fuel valve in the reverse order of removal.Open the tap and check for leaks.FUEL INJECTION ENGINE (TE-SMR)On vehicles which are fitted with a fuel injection engine, thefuel pump is built into the fuel tank and there is no tap mountedon the fuel supply system. The quantity of remaining fuel isindicated on the digital dash-board by the special warninglight (see on page 14).EN1231. Fuel tank cap2. Fuel cock3. Fuel hoseA. Tap ring nutA11
- Page 1 and 2: ENGLISH1
- Page 3 and 4: IMPORTANTThe reference for recognit
- Page 5 and 6: VEHICLE IDENTIFICATION NUMBER (V.I.
- Page 7 and 8: Control location1. Front brake leve
- Page 9: FINAL RATIOS1st gear (TE 310) . . .
- Page 13 and 14: CARBURETOR CHOKE (TC-TXC)The starte
- Page 15 and 16: 2- SPEED / CLOCK (figure 2)- SPEED:
- Page 17 and 18: THROTTLE CONTROLThe throttle knob (
- Page 19 and 20: REAR BRAKE CONTROLThe rear brake co
- Page 21 and 22: ENGINE START (TE-SMR)With cold engi
- Page 23 and 24: ENGINE START (TC-TXC)Proceed as fol
- Page 25 and 26: 8) COMPLETELY lower the pedal (4) u
- Page 27 and 28: STOPPING THE MOTORCYCLE AND THE ENG
- Page 29 and 30: COOLANT LEVEL CHECKCheck level (1)
- Page 31 and 32: THROTTLE CABLE ADJUSTMENTTo check t
- Page 33 and 34: SPARK PLUG CHECKUse NGK CR8EB spark
- Page 35 and 36: AIR FILTER CHECK (TE-SMR)Turn rear
- Page 37 and 38: ADJUSTMENT OF THE CONTROL LEVER AND
- Page 39 and 40: CHECKING THE FLUID LEVELThe level (
- Page 41 and 42: ADJUSTING THE SUSPENSIONS ACCORDING
- Page 43 and 44: OIL FORK LEVELFor the regular fork
- Page 45 and 46: OIL FORK LEVELFor the regular fork
- Page 47 and 48: ADJUSTING THE SHOCK ABSORBERThe rea
- Page 49 and 50: CHAIN ADJUSTMENT (Fig. A)Chain shou
- Page 51 and 52: 2 - Check that the chain is neither
- Page 53 and 54: REASSEMBLING THE FRONT WHEELFit the
- Page 55 and 56: TIRESCare should be taken to keep t
- Page 57 and 58: PADS CLEANINGBe careful that no dis
- Page 59 and 60: DISC CLEANINGPoor braking can also
CONTROLSFUEL COCK (<strong>TC</strong>-<strong>TXC</strong>)The left-side tap (2) is a screw tap: screw the ring nut (A) toclose the tap, loosen the ring nut to open the tap.WARNING*: Be careful not to touch the hotengine while operating the fuel valve.A fuel filter is incorporated in the fuel valves. Accumulation ofdirt in the filter will restrict the flow of the fuel to the carburetor.Therefore, the fuel filter should be serviced periodically.1 Loosen the input plug (1) on the fuel tank and close the tap;2 Remove the fuel hose (3) from the carburetor and insert thehose in a vessel;3 Open the tap and drain the fuel out of the tank;4 Remove the fuel valve by removing the screws. Wash the fuelscreen filter in cleaning solvent;5 Reassemble the fuel valve in the reverse order of removal.Open the tap and check for leaks.FUEL INJECTION ENGINE (<strong>TE</strong>-SMR)On vehicles which are fitted with a fuel injection engine, thefuel pump is built into the fuel tank and there is no tap mountedon the fuel supply system. The quantity of remaining fuel isindicated on the digital dash-board by the special warninglight (see on page 14).EN1231. Fuel tank cap2. Fuel cock3. Fuel hoseA. Tap ring nutA11