Rust-Oleum Corporation January 1999 - RustOleum.com

Computer Landscape Generation and SmoothingMasters Comprehensive ExamGrant MacklemSpring 20031

primer.C. Repair cracked and eroded concrete in accordance with manufacturer's instructions. Removeand repair unsound concrete.D. Provide abraded concrete surface texture similar to 60 grit sandpaper by acid etching, abrasiveblasting, or mechanical preparation.1. If acid etching is performed, completely remove acid residue from concrete surface with aminimum 2,000 psi pressure water wash.2. If abrasive blasting or mechanical preparation is performed, completely remove concretedust from concrete surface.3.3 APPLICATIONSpecifier Notes: Delete the following sentence if cove base is not required.A. Install cove base before application of flooring in accordance with manufacturer's instructions atlocations indicated on drawings.B. Ensure concrete surface is visibly dry.C. Mix component materials in accordance with manufacturer's instructions. Do not add thinners tomaterials.D. Apply materials while air temperature is stable or decreasing.E. Apply primer to prepared concrete surface in accordance with manufacturer's instructions.F. Apply base over primer in accordance with manufacturer's instructions.G. Apply topping over base in accordance with manufacturer's instructions.Specifier Notes: Consult Rust-Oleum for assistance in specifying required flooring system thicknessfor the specific application.H. Apply flooring system at a thickness of 1/4 inch.I. Spread aggregate in accordance with manufacturer's instructions to produce even and completecoverage of topping surface.Specifier Notes: BriteCast HD flooring system is available in two standard surface textures - HighProfile and Low Profile. Texture depends on the number of coats of BriteCast Sealer applied.High Profile: High surface texture, best used in wet areas. Relatively aggressive anti-skid surface,with peaks and valleys of the aggregate equally sealed. One coat of BriteCast Sealer applied.Low Profile: Less aggressive surface texture, easier to clean. Light texture, leaving only the tips ofthe aggregate above the surface of the sealer. Two coats of BriteCast Sealer applied.Consult Rust-Oleum for assistance in specifying the required texture for the specific application.J. Apply sealer over floor topping in accordance with manufacturer's instructions. Apply [highBriteCast HD 09670 - 6

profile] [low profile] texture.3.4 PROTECTIONA. Protect floor topping system, when cured at temperatures between 65 and 90 degrees F:1. From Foot Traffic: Minimum of 10 to 12 hours.2. From Full Physical Use: Minimum of 16 to 30 hours.3. From Full Chemical Exposure: Minimum of 4 days.END OF SECTIONBriteCast HD 09670 - 7