OBD Operation Summary for 6.7L Diesel - MotorCraftService.com

Typical Camshaft and Crankshaft Sensor Monitor Entry Conditions:Entry condition Minimum MaximumP0016 – Engine running or crankingP0315 – Overrun/decel fuel shut-offP0335 – Engine running or crankingP0336 – Engine running or crankingP0340 – Engine running or crankingP0341 – Engine running or crankingTypical Camshaft Sensor Monitor Malfunction Thresholds:P0016 – If the location of the gap on the crankshaft sensor wheel occurs at a location on the camshaft sensorwheel that is more than 18 degrees from the expected location for two detection attempts, the code is setP0315 – If after 5000 total seconds of overrun/decel fuel shut-off, the system has been unable to learn crankshaftwheel deviation corrections, the code is setP0335 – If no signal is detected from the crankshaft sensor, the code is setP0336 – If the gap in the 60-2 tooth wheel is not detected for three revolutions, the code is setP0340 – If no signal is detected from the camshaft sensor, the code is setP0341 – If the segment profile detected does not match the segment profile shown in the figure above, the codeis setFORD MOTOR COMPANY REVISION DATE: FEBRUARY 9, 2012 09.01.00.02-PAGE 92 OF 157