Apple Disk II Technical Procedures
Apple Disk II Technical Procedures Apple Disk II Technical Procedures
Disk ][ Technical ProceduresSection 1Take-apartContents:Removing the Cover 1.3Replacing the Cable 1.5Replacing the Analog Card 1.7Replacing the Collet Hub 1.9Replacing the Head Load Button 1.10disk ][ take-apart rev. 8-31-82 page 1.1
- Page 1: DISK ][ TECHNICAL PROCEDURESTABLE O
- Page 6 and 7: disk ][ take-apart rev. 8-31-82 pag
- Page 8 and 9: disk ][ take-apart rev. 8-31-82 pag
- Page 10 and 11: disk ][ take-apart rev. 8-31-82 pag
- Page 12 and 13: E. REPLACING THE HEAD LOAD BUTTONTh
- Page 14 and 15: disk ][ adjustments rev. 8-31-82 pa
- Page 16 and 17: disk ][ adjustments rev. 8-31-82 pa
- Page 19 and 20: C. DISKETTE STOP GUIDE ADJUSTMENTTh
- Page 21 and 22: 11. Set the speed so that it indica
- Page 23: E. WRITE-PROTECT SWITCH ADJUSTMENTI
- Page 27 and 28: A. GENERALBefore doing any of the p
- Page 29 and 30: 7. Connect the probe tip to TP8 and
- Page 31 and 32: C. AZIMUTH TESTThe azimuth test sho
- Page 33 and 34: The Test:12. Change the oscilloscop
- Page 35 and 36: D. CARRIAGE LIMITER ADJUSTMENTThe C
- Page 37 and 38: The Adjustment:12. Loosen the adjus
- Page 39 and 40: Disk Safety Check6. Set the oscillo
- Page 41 and 42: 18. If the drive needs adjustment,
- Page 43 and 44: SHUGART drive adjustment:23. Rotate
- Page 45 and 46: 7. Connect the probe tip to TP5 and
- Page 47: 15. Change the oscilloscope's sweep
- Page 51: Disk ][ Troubleshooting ChartSympto
<strong>Disk</strong> ][ <strong>Technical</strong> <strong>Procedures</strong>Section 1Take-apartContents:Removing the Cover 1.3Replacing the Cable 1.5Replacing the Analog Card 1.7Replacing the Collet Hub 1.9Replacing the Head Load Button 1.10disk ][ take-apart rev. 8-31-82 page 1.1