SNMP-GSH2402 - kamery airlive airlivecam

More documents

Recommendations

Info

Tx 65-127 Bytes:Number of 65 ~ 126-byte frames in good and bad packets transmitted.Tx 128-255 Bytes:Number of 127 ~ 255-byte frames in good and bad packets transmitted.Tx 256-511 Bytes:Number of 256 ~ 511-byte frames in good and bad packets transmitted.Tx 512-1023 Bytes:Number of 512 ~ 1023-byte frames in good and bad packets transmitted.Tx 1024-Bytes:Number of 1024-max_length-byte frames in good and bad packetstransmitted.Rx CRC/Alignment:Number of Alignment errors and CRC error packets received.Rx Undersize:Number of short frames (
3-3. MirrorFunction name:Mirror ConfigurationFunction description:Mirror Configuration is to monitor the traffic of the network. For example, weassume that Port A and Port B are Monitoring Port and Monitored Portrespectively, thus, the traffic received by Port B will be copied to Port A formonitoring.Note:When configuring the mirror function, you should avoid setting a port to be asniffer port and aggregated port at the same time. It will cause somethingwrong.Parameter description:Mode:Used for the activation or de-activation of Port Mirror function. Default isdisable.Monitoring Port:Set up the port for monitoring. Valid port is Port 1~24 and default isPort 1.Monitored Port:Set up the port for being monitored. Just tick the check box () besidethe port x and valid port is Port 1~24.Fig. 3-1561
Page 3 and 4:
3-10. VLAN-------------------------
Page 5 and 6:
About this user’s manualIn this u
Page 7:
• Key Features in the DeviceQoS:S
Page 10 and 11:
1-4. View of 24 Gigabit L2 Managed
Page 12 and 13:
1-5. View of the Optional ModulesIn
Page 14 and 15: • TP Port and Cable Installation
Page 16 and 17: 2-1-3-1. Cabling Requirements for T
Page 18 and 19: Case1: All switch ports are in the
Page 20 and 21: 2-1-4. Configuring the Management A
Page 22 and 23: • Set IP Address, Subnet Mask and
Page 24 and 25: Fig. 2-10 the Login Screen for Web2
Page 26 and 27: Class D and E:Class D is a class wi
Page 28 and 29: For different network applications,
Page 30 and 31: Fig. 2-14 Peer-to-peer Network Conn
Page 32 and 33: In the switch, it supports a simple
Page 34 and 35: • The Information of Page Layout
Page 36 and 37: 3-1-1. System InformationFunction n
Page 38 and 39: 3-1-2. IP ConfigurationIP configura
Page 40 and 41: IP address:Users can configure the
Page 42 and 43: 3-1-3. Time ConfigurationThe switch
Page 44 and 45: Day Light Saving End :This is used
Page 46 and 47: 3-1-5. Management PolicyThrough the
Page 48 and 49: IP Range:The switch supports two ki
Page 50 and 51: Parameter description:Fig. 3-8State
Page 52 and 53: 3-2. Port ConfigurationFour functio
Page 54 and 55: Speed / Duplex Mode:Display the spe
Page 56 and 57: Vendor SN (Serial Number):Show the
Page 58 and 59: Mode:Set the speed and duplex of th
Page 61 and 62: Rx Packet:The counting number of th
Page 63: Rx Low Priority Packets:Number of R
Page 67 and 68: Broadcast & Multicasat for Ingress
Page 69 and 70: Function name:Per Port PriorityFunc
Page 71 and 72: Bit 0, Bit 1, Bit 2:According to th
Page 73 and 74: Bit 0, Bit 1, Bit 2:According to th
Page 75 and 76: Prioritize Streaming Audio/Video:Be
Page 77 and 78: Function name:IP Diffserv Classific
Page 79 and 80: Default SNMP function : EnableDefau
Page 81 and 82: Parameter description:IGMP snooping
Page 83 and 84: Add:A new entry of allowed group co
Page 85 and 86: 3-9. DHCP BootThe DHCP Boot functio
Page 87 and 88: Metro Mode:The Metro Mode is a quic
Page 89 and 90: 3-10-2. Tag-based GroupFunction nam
Page 91 and 92: 3-10-3. Port-based GroupFunction na
Page 93 and 94: modify a group‘s description and
Page 95 and 96: Role:This is an egress rule of the
Page 97 and 98: Port:The port that exists in the se
Page 99 and 100: Function Name:Static ForwardFunctio
Page 101 and 102: Function name:MAC AliasFunction des
Page 103 and 104: 3-12. GVRP ConfigurationGVRP is an
Page 105 and 106: Normal:It is Normal Registration. T
Page 107 and 108: LeaveEmpty Message Packets:Number o
Page 109 and 110: 3-13. STP ConfigurationThe Spanning
Page 111 and 112: 3-13-2. STP ConfigurationThe STP, S
Page 113 and 114: 3-13-3. STP Port ConfigurationFunct
Page 115 and 116:
M Check:Migration Check. It forces
Page 117 and 118:
Per Trunking Group supports a maxim
Page 119 and 120:
Aggtr:Status:Aggtr is an abbreviati
Page 121 and 122:
Function name:LACP Detail (LACP Agg
Page 123 and 124:
3-15. 802.1X Configuration802.1X po
Page 125 and 126:
Authentication serverFig. 3-54CBAut
Page 127 and 128:
Only MultiHost 802.1X is the type o
Page 129 and 130:
Function name:802.1X Mode SettingFu
Page 131 and 132:
Function name:Param. SettingFunctio
Page 133 and 134:
3-16. Alarm ConfigurationAlarm Conf
Page 135 and 136:
Parameter description:Email:Mail Se
Page 137 and 138:
3-17-1. Save/RestoreFunction name:S
Page 139 and 140:
Function name:Restore User Configur
Page 141 and 142:
3-18. DiagnosticsThree functions, i
Page 143 and 144:
Function name:Ping TestFunction des
Page 145 and 146:
3-20. LogThis function shows the lo
Page 147 and 148:
3-21. Firmware UpgradeSoftware upgr
Page 149 and 150:
3-23. LogoutYou can manually logout
Page 151 and 152:
4. Operation of CLIManagement4-1. C
Page 153 and 154:
4-2. Commands of CLITo see the comm
Page 155 and 156:
helpSyntax:helpDescription:To show
Page 157 and 158:
logoutSyntax:logoutDescription:When
Page 159 and 160:
save userSyntax:save userDescriptio
Page 161 and 162:
set port-controlSyntax:set port-con
Page 163 and 164:
set state Description:To configur
Page 165 and 166:
port 2) port control : AutoreAuthMa
Page 167 and 168:
modifySyntax:modify Description:To
Page 169 and 170:
set serverSyntax:set server Descrip
Page 171 and 172:
del trapSyntax:del trap Description
Page 173 and 174:
Example:SNMP-GSH2402(alarm-events)#
Page 175 and 176:
set phone-numberSyntax:set phone-nu
Page 177 and 178:
• bandwidthdisable egress-rateSyn
Page 179 and 180:
showSyntax:showDescription:To displ
Page 181 and 182:
import user-confSyntax:import user-
Page 183 and 184:
• dhcp-bootset dhcp-bootSyntax:se
Page 185 and 186:
• firmwareset upgrade-pathSyntax:
Page 187 and 188:
SNMP-GSH2402(gvrp)# group 2SNMP-GSH
Page 189 and 190:
set restrictedSyntax:set restricted
Page 191 and 192:
show counterSyntax:show counter Des
Page 193 and 194:
set modeSyntax:set mode Description
Page 195 and 196:
set ipSyntax:set ip Description:T
Page 197 and 198:
showSyntax:showDescription:To show
Page 199 and 200:
searchSyntax:search Description:T
Page 201 and 202:
addSyntax:add [alias]Description
Page 203 and 204:
• managementaddSyntax:Usage:set [
Page 205 and 206:
edit [#]: the specific management p
Page 207 and 208:
• max-pkt-lenset lenSyntax:set le
Page 209 and 210:
showSyntax:showDescription:To displ
Page 211 and 212:
enable flow-controlSyntax:enable fl
Page 213 and 214:
Port 23 SFP information------------
Page 215 and 216:
set diffservSyntax:set diffserv De
Page 217 and 218:
set tosSyntax:set tos Description
Page 219 and 220:
setSyntax:set get-community set set
Page 221 and 222:
set configSyntax:set config Desc
Page 223 and 224:
show portSyntax:show portDescriptio
Page 225 and 226:
• systemset contactSyntax:set con
Page 227 and 228:
• tftpset serverSyntax:set server
Page 229 and 230:
set ntpSyntax:set ntp Description:
Page 231 and 232:
show aggtr-viewSyntax:show aggtr-vi
Page 233 and 234:
• vlandel port-groupSyntax:del po
Page 235 and 236:
set modeSyntax:set mode [up-link]D
Page 237 and 238:
set tag-groupSyntax:set tag-group
Page 239 and 240:
• vsdisableSyntax:disableDescript
Page 241 and 242:
5. Maintenance5-1. Resolving No Lin
Page 243 and 244:
Hardware Specifications• Standard
Page 245 and 246:
Management Software SpecificationsA
show all

SNMP-GSH2402 - kamery airlive airlivecam

Create successful ePaper yourself

Delete template?

Save as template?