SNMP-GSH2402 - kamery airlive airlivecam

Function name:Port StatusFunction Description:Report the latest updated status of all ports in this switch. When any one of theports in the switch changes its parameter displayed in the page, it will beautomatically refreshed the port current status about every 5 seconds.Parameter Description:Port No:Media:Link:Display the port number. The number is 1 – 24. Both port 23 and 24 areoptional modules.Show the media type adopted in all ports. The Port 23 and Port 24 areoptional modules, which support either fiber or UTP media with eitherGigabit Ethernet (1000Mbps) or 10/100Mbps Fast Ethernet port. Theymay have different media types and speed. Especially, fiber port hascomprehensive types of connector, distance, fiber mode and so on. Theswitch describes the module ports with the following page.Show that if the link on the port is active or not. If the link is connected toa working-well device, the Link will show the link “Up”; otherwise, it willshow “Down”. This is determined by the hardware on both devices of theconnection.No default value.State:Show that the communication function of the port is “Enabled” or“Disabled”. When it is enabled, traffic can be transmitted and received viathis port. When it is disabled, no traffic can be transferred through thisport. Port State is configured by user.Default: Enabled.Auto Negotiation:Show the exchange mode of Ethernet MAC. There are two modessupported in the switch. They are auto-negotiation mode “Enabled” andforced mode “Disabled”. When in “Enabled” mode, this function willautomatically negotiate by hardware itself and exchange each other thecapability of speed and duplex mode with other site which is linked, andcomes out the best communication way. When in “Disabled” mode, bothparties must have the same setting of speed and duplex, otherwise, bothof them will not be linked. In this case, the link result is “Down”.Default: Enabled49