SNMP-GSH2402 - kamery airlive airlivecam
SNMP-GSH2402 - kamery airlive airlivecam SNMP-GSH2402 - kamery airlive airlivecam
In the switch, it supports a simple user management function allowing onlyone administrator to configure the system at the same time. If there are two or moreusers using administrator’s identity, the switch will allow the only one who logins firstto configure the system. The rest of users, even with administrator’s identity, canonly monitor the system. For those who have no administrator’s identity, can onlymonitor the system. There are only a maximum of three users able to loginsimultaneously in the switch.To optimize the display effect, we recommend you use Microsoft IE 6.0above, Netscape V7.1 above or FireFox V1.00 above and have the resolution1024x768. The switch supported neutral web browser interface.In Fig. 3-2, for example, left section is the whole function tree with web userinterface and we will travel it through this chapter.Fig. 3-128
3-1. Web Management Home OverviewAfter you login, the switch shows you the system information as Fig. 3-2. Thispage is default and tells you the basic information of the system, including “ModelName”, “System Description”, “Location”, “Contact”, “Device Name”, “System UpTime”, “Current Time”, “BIOS Version”, “Firmware Version”, “Hardware-MechanicalVersion”, “Serial Number”, “Host IP Address”, “Host Mac Address”, “Device Port”,“RAM Size” and “Flash Size”. With this information, you will know the softwareversion used, MAC address, serial number, how many ports good and so on. This ishelpful while malfunctioning.Fig. 3-229
- Page 3 and 4: 3-10. VLAN-------------------------
- Page 5 and 6: About this user’s manualIn this u
- Page 7: • Key Features in the DeviceQoS:S
- Page 10 and 11: 1-4. View of 24 Gigabit L2 Managed
- Page 12 and 13: 1-5. View of the Optional ModulesIn
- Page 14 and 15: • TP Port and Cable Installation
- Page 16 and 17: 2-1-3-1. Cabling Requirements for T
- Page 18 and 19: Case1: All switch ports are in the
- Page 20 and 21: 2-1-4. Configuring the Management A
- Page 22 and 23: • Set IP Address, Subnet Mask and
- Page 24 and 25: Fig. 2-10 the Login Screen for Web2
- Page 26 and 27: Class D and E:Class D is a class wi
- Page 28 and 29: For different network applications,
- Page 30 and 31: Fig. 2-14 Peer-to-peer Network Conn
- Page 34 and 35: • The Information of Page Layout
- Page 36 and 37: 3-1-1. System InformationFunction n
- Page 38 and 39: 3-1-2. IP ConfigurationIP configura
- Page 40 and 41: IP address:Users can configure the
- Page 42 and 43: 3-1-3. Time ConfigurationThe switch
- Page 44 and 45: Day Light Saving End :This is used
- Page 46 and 47: 3-1-5. Management PolicyThrough the
- Page 48 and 49: IP Range:The switch supports two ki
- Page 50 and 51: Parameter description:Fig. 3-8State
- Page 52 and 53: 3-2. Port ConfigurationFour functio
- Page 54 and 55: Speed / Duplex Mode:Display the spe
- Page 56 and 57: Vendor SN (Serial Number):Show the
- Page 58 and 59: Mode:Set the speed and duplex of th
- Page 61 and 62: Rx Packet:The counting number of th
- Page 63 and 64: Rx Low Priority Packets:Number of R
- Page 65 and 66: 3-3. MirrorFunction name:Mirror Con
- Page 67 and 68: Broadcast & Multicasat for Ingress
- Page 69 and 70: Function name:Per Port PriorityFunc
- Page 71 and 72: Bit 0, Bit 1, Bit 2:According to th
- Page 73 and 74: Bit 0, Bit 1, Bit 2:According to th
- Page 75 and 76: Prioritize Streaming Audio/Video:Be
- Page 77 and 78: Function name:IP Diffserv Classific
- Page 79 and 80: Default SNMP function : EnableDefau
- Page 81 and 82: Parameter description:IGMP snooping
In the switch, it supports a simple user management function allowing onlyone administrator to configure the system at the same time. If there are two or moreusers using administrator’s identity, the switch will allow the only one who logins firstto configure the system. The rest of users, even with administrator’s identity, canonly monitor the system. For those who have no administrator’s identity, can onlymonitor the system. There are only a maximum of three users able to loginsimultaneously in the switch.To optimize the display effect, we recommend you use Microsoft IE 6.0above, Netscape V7.1 above or FireFox V1.00 above and have the resolution1024x768. The switch supported neutral web browser interface.In Fig. 3-2, for example, left section is the whole function tree with web userinterface and we will travel it through this chapter.Fig. 3-128
Change language