SNMP-GSH2402 - kamery airlive airlivecam

4. Operation of CLIManagement4-1. CLI ManagementRefer to Chapter 2 for basic installation. The following description is the brief of thenetwork connection.-- Locate the correct DB-9 null modem cable with female DB-9 connector. Nullmodem cable comes with the management switch. Refer to the Appendix B fornull modem cable configuration.-- Attach the DB-9 female connector to the male DB-9 serial port connector on theManagement board.-- Attach the other end of the DB-9 cable to an ASCII terminal emulator or PC Com-1, 2 port. For example, PC runs Microsoft Windows HyperTerminal utility.-- At “Com Port Properties” Menu, configure the parameters as below: (see the nextsection)Baud rate 57600Stop bits 1Data bits 8ParityNFlow control none4-1-1. LoginThe command-line interface (CLI) is a text-based interface. User can accessthe CLI through either a direct serial connection to the device or a Telnet session.The default values of the managed switch are listed below:Username: adminPassword: adminAfter you login successfully, the prompt will be shown as “#“ if you are thefirst login person and your authorization is administrator; otherwise it may show “$“.See the following two figures. The former means you behave as an administratorand have the access right of the system. As to the latter, it means you behave as aguest and are only allowed to view the system without the permission to do anysetting for this switch.147