Windows Setup Guide for ST-B10 - Toshiba Tec

More documents

Recommendations

Info

Windows Setup Guide for ST-B10TOSHIBA TEC CORPORATION EAA-03033The following calibration screen appears. Perform a calibration by touching the mark wheneverit appears. (The mark appears three times.)Note:The calibration screen appears one time each a touch panel. The calibration screenappears two times at two touch panels.In the case of Dual Display, please refer to the table as below.Remainder to use dual touch panelDisplay modesRemainder of CalibrationThe calibration screen appears on both panels two times. When youClone calibrate touch panels, sequence of calibration does not make anydifference.ExtendeddesktopThe calibration screen appears Primary display. After that, the screenappears Secondary display.Remainder to use single touch panel and another non-touch displayDisplay modesRemainder of CalibrationCloneExtendeddesktopThe calibration screen appears both monitors. Please calibrate touchpanel.The calibration screen appears Primary display.If Secondary display is touch panel, press “Esc” key from keyboard. Thecalibration screen appears Secondary display.69
Windows Setup Guide for ST-B10TOSHIBA TEC CORPORATION EAA-03033After the mark was touched three times, two buttons appear at the center of the screen. Click onthe check mark button to complete the calibration.If using dual touch panel, the calibration screen re-appears.70
Page 1 and 2:
Windows Setup Guide for ST-B10TOSHI
Page 3 and 4:
Page 5 and 6:
Page 7 and 8:
Page 9 and 10:
Page 11 and 12:
Page 13 and 14:
Page 15 and 16:
Page 17 and 18:
Page 19 and 20:
Page 21 and 22: Windows Setup Guide for ST-B10TOSHI
Page 71: Windows Setup Guide for ST-B10TOSHI
show all

Windows Setup Guide for ST-B10 - Toshiba Tec

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?