Download - Buderus

Collector sensor 77 Collector sensorNOTICEThe collector sensor is included with thesolar controller.Observe the installation location for singleor dual row collector systems (Fig. 47, .ABSYSTEM DAMAGECAUTION!Sensor pointfrom damaged sensor cable. Protect the cable from possibledamage (e.g. by birds and rodents).The collector sensor must be installed in the collectorconnected to the supply line (Fig. 47, [2]).– Location (Fig. 47, [A]) for single row collectorsystems.122 163043965.54-1.SDFig. 47 Collector sensor installation location (schematic)1 Return line2 Supply line– Location (Fig. 47, [B]) for multi-row collectorsystems.Installing the collector sensorThe collector sensor (Fig. 48, [1]) must be inserted intothe sensor well as far as it will go (approx. 10"(250 mm)). Using the collector sensor or screwdriver, puncturethe membrane of the sensor well (Fig. 48, [3]). Screw strain relief (Fig. 48, [2]) into sensor well. Insert collector sensor approx. 10" (250 mm) into thesensor well (until it bottoms out). Tighten strain relief by hand (Fig. 48, [2]). Use cable ties or similar to route the sensor cablesecurely until it meets up with the twin tube.32 1NOTICEIf the membrane (Fig. 48, [3]) on thewrong collector was accidentallypunctured, it can be resealed using theplug from the connection kit. First removethe nut in the sensor well using the strainrelief (Fig. 48, [2]).Fig. 48 Inserting the collector sensor into the sensor well1 Collector sensor2 Strain relief3 Sensor wellRoute the sensor cable along the pipework using zipties.Logasol SKN 3.0 - We reserve the right to make any changes due to technical modifications. 33