Download - Buderus

6Collector Installation Push the hose clamp over the bead on the collectorconnection and pull the locking ring.SYSTEM DAMAGECAUTION!from unsecured solar hoses and dummyplug. Secure every solar hose to thecollector connection using a hoseclamp (Fig. 44).63043965.49-1.SDFig. 44Solar hose with secured hose clamp Tighten the screw on the double-sided collectorclamp using the size 5 Allen key. Verify the clampengages with the lower edge of the collector. It maybe necessary to slightly adjust the position of thesecond collector.NOTICEWhen the screw is tightened, the plasticspacers holding the clamp apart will breakaway. Discard this piece.1The hook (Fig. 45, [1]) on the collector clamp now gripsthe lower collector edge.Repeat the procedure for all the other collectors.Installing the single sided collector clamp on thelast collectorOnce all collectors are installed, the two remainingsingle-sided collector clamps can be attached. Push the single-sided collector clamp (Fig. 46, [1])into all profile rails. Push collector clamp up against the collectorframe and screw in place using size 5 Allen key(Fig. 46, [2]).NOTICEFig. 45163043965.48-1.SDDouble-sided collector clamp between two collectors2When the screw is tightened, the plasticspacer holding the clamp apart will breakaway. Discard this piece.Fig. 46Single-sided collector clamp (left)63043965.50-1.SD32Logasol SKN 3.0 - We reserve the right to make any changes due to technical modifications.