Download - Buderus

Collector Installation 6 Carefully push collector (Fig. 41, [1]) up against thesingle-sided collector clamp and align horizontally. Tighten the screw on the single-sided collector clamp(Fig. 41, [2]) using size 5 Allen key.1NOTICEWhen the screw is tightened, the plasticspacer holding the clamp apart will breakaway. Discard this piece.2The hook on the collector clamp (Fig. 41, [2]) now gripsthe lower collector edge.63043965.45-1.SDFig. 41Single-sided collector clamp in placeInstalling a double-sided collector clamp Insert the double-sided collector clamp, nut first, intothe connector between two horizontal rails, then turn90 degrees clockwise and push down onto the railwith the plastic cover (Fig. 42, [1]) sitting on top of thehorizontal rail.12 Push double-sided collector clamp against thecollector frame.1NOTICE1Do not tighten the screw until the secondcollector has been pushed against thedouble-sided collector clamp.Fig. 42Installing a double-sided collector clamp63043965.46-1.SDPutting the second collector in place Place second collector along with the preassembledsolar hoses (Fig. 43, [1]) onto the profile rails and letit slide into the collector hangers.1 Push the second hose clamp (Fig. 43, [3]) onto thesolar hose.2 Push the collector towards the first collector(Fig. 43, [2]) in such a way that the preassembledsolar hoses are pushed onto the left-handconnections on the first collector.3 2Fig. 43Pushing second collector towards the first63043965.47-1.SDLogasol SKN 3.0 - We reserve the right to make any changes due to technical modifications. 31