Rover 75 Owner's Handbook - 3rd Edition - Eng - RoverClub-BG.com

Bulb ReplacementWhen removing the bulb, the following tips will make thejob easier.• Always remove the electrical connector BEFOREunhooking the wire securing clip.• Examine the illustration carefully to see how the wiresecuring clip works.• Before replacing the electrical connector, refer to theillustration to check which way round the connector needsto be to enable it to fit onto the spade-type contacts on thebulb.Replacement of the bulb is a reversal of the removal process.SidelightThe sidelight holder is immediately below the headlight bulb.With the circular rubber cover removed, pull the bulb holderfrom the light unit and pull the bulb to remove from theholder.NOTE: Replacing the outboardheadlight bulbs must be done by‘feel’ and, in the most part, withone hand only.Replacement bulb: 5 watt.Replacing the access panelClip the protrusion at the top of the access panel into theaperture in the wheelarch liner and push the panel upwards asfar as it will go. The smaller protrusion at the bottom of thepanel can then be clipped into the corresponding cut-out atthe bottom of the wheelarch liner aperture. Finally, engagethe turnbuckle screw and turn a quarter turn to left or rightto fully secure the access panel.182