SAM4s ER-5115 Operators Manual.pdf

Changing PaperLoading the Receipt Paper1. Place the other roll of paper into the small tray on the left.2. Make sure the paper unrolls from the bottom of the roll.3. Fold back approximately 6" of paper and insert the folded end of the tape into the feedslot just in front of the paper tray at the rear of the printer.*4. Press the RCPT FEED key until the paper comes through the printer. Continue topress the key until 3 - 4 inches of paper are through the printer.5. Replace the printer cover, making sure the receipt paper comes out through the openingin the printer cover.* Ribbon must be in place when changing paper.Follow the same steps anytime you need to replace receipt or detail paper. All steps are the same.However, when replacing detail paper, cut the old detail paper at the spot where the printing stops.Then use the DETL FEED key to free the old paper from the printer. Remove the old detail paperfrom the rewind spindle.SAM4s ER-5115 Electronic Cash Register Introduction 17