Libraries for Building Automation Function Block ... - Wago

Actuation of Continuous Dampers (FbContinuousDamper)Actuation of Continuous Dampers (FbContinuousDamper)WAGO-I/O-PRO Library ElementsCategory:Building AutomationName:FbContinuousDamperType: Function Function block X ProgramName of library:Building_HVAC_03.libApplicable to:See Release NoteInput parameters: Data type: Comment:xEnableSystem BOOL Enable FbStartStopDefault setting = TRUExNightVentilation BOOL Opening damper during night ventilationrReferencePosition REAL Reference position of the continuousdamper [%]rActualPosition REAL Actual position of the continuous damper[%]xManualOperation BOOL Enable manual operationrManualValue REAL Set value manual operation [%]Value range = 0 – 100%typConfigContinuous Configuration parameters:Damper.tOnDelayAlarm TIME ON-delay for alarmDefault setting = t#5 m.rMinDeviationMovement REAL Minimum deviation for detection of motion[%]Default setting = 5.rTolerance REAL Max. deviation, specified/actual position[%]Default setting = 3.rY_Min REAL Minimum setting value for damper [%]Default setting = 3.xFeedbackDamper BOOL Check-back signal Damper positionpresentDefault setting = FALSExQuit BOOL Error message acknowledgementInput/output parameters: Data type: Comment:dwOperatingMinutes DWORD Operating minutes for continuous damperReturn value:Data type: Comment:rY REAL Set value for damperValue range = 0 – 100wY WORD Set value for damplerValue range: 0 −32767Subject to design changes WAGO Kontakttechnik GmbH & Co. KG P:O. box 2880 • D-32385 Minden Phone: 05 71 / 8 87-0 E-Mail: info@wago.comCopyright © 2013 Hansastr. 27 • D-32423 Minden Fax.: +49 (0) 5 71 / 8 87-169 Web: http://www.wago.com36