specifications - FAACO - Federal Aviation Administration Contract ...

3003 Sheet, tube or pipe5005 General purpose sheet5056 Nails and Rivets2024 Screws, bolts and nutsFTWIC-2235June, 2009J. STAINLESS STEEL:Appropriate for the intended usage, complying with ANSI Type 300 or 301 (17%/7%) or302 (18%/8%). Finish shall be as noted on the drawing.K. STEEL PIPE:Welded or seamless type, standard weight, schedule 40 steel tubing conforming to ASTMA-53. Steel tube shall conform to ASTM A 500, grade B.L. SHOP PAINT:Shop paint must be suitable for finish coats as specified in Section 09901 PAINTING.Contractor shall coordinate. Shop paint shall be a Zinc Chromate Primer formiscellaneous steel; TNEMEC 99 or approved equal for structural components, andTNEMEC 10-99 or approved equal for components to be fireproofed.M. FASTENERS:Appropriate for the intended usage. Fasteners used with galvanized steel shall be zinccoated. Fasteners used on non-ferrous metal shall be bronze or brass. Fasteners shallinclude but not be limited to:1. Steel bolts - Low carbon steel complying with ASTM A-307 or A-325.2. Nails and Spikes - Fasteners complying with Fed. Spec. IV. FF-P-636.3. Self Drilling Fasteners (SDF) - Corrosive resistant, hex-headed drill pointed, sizeas appropriate.4. Power Activated Fasteners (PAF) - Tempered A-151 steel with a minimumtensile strength of 270,000 psi, complying with Fed. Spec. - P3958, Hilti, orapproved equal.5. Sleeve bolts - Ramset "Dynabolt", or approved equal.6. Concrete expansion bolts - Hilti "KwikBolt II", or approved equal.7. CMU Fastener - Hilti "KwikTog", or approved equal.8. Metal Deck fasteners - Corrosive resistant, hexheaded, drill pointed fasteners,Teks, or approved equal.9. Self-drilling anchors bolts - Zinc-plated, case hardened body with expandingplug, Hilti "HHS" or approved equal.N. ZINC-RICH COATING:Specially formulated compound conforming to Navy Specification MIL-P-21035 thatproduces a coating of approximately 3.0 mils thickness containing not less than 95percent zinc when applied in one coat according to manufacturer's instructions.05500-5