specifications - FAACO - Federal Aviation Administration Contract ...

01400 QUALITY CONTROLFTWIC-2235June, 2009PART 1.00GENERAL1.01 WORK INCLUDED:A. FAA will secure the services of an independent, qualified testing laboratory for thepurpose of performing testing as required by the various sections of the specifications.Testing performed by the FAA will be paid for by the Government. Contractor shallcooperate fully with the Contracting Officer and his testing laboratory to facilitate thetesting services.B. When re-testing is required due to noncompliance with the requirements of thespecifications, Contractor shall pay for the re-testing.1.02 RELATED WORK SPECIFIED ELSEWHERE:Project Administration Section 01040Job Management Section 01041Testing of HVAC Systems Division 15Testing of Electrical Systems Division 161.03 DELIVERY AND STORAGE:Test cylinders made at the construction site shall be handled and protected in accordance withrecognized test procedures.1.04 JOB CONDITIONS:A. The Contracting Officer reserves the right to perform testing at any state of construction.Contractor shall make the site available to the Government's testing organization, andshall cooperate fully in the performance of these tests. Where the Contracting Officer hasmade it known that certain testing is to be performed, Contractor shall give FAAadequate notice before proceeding with work that would interfere with testing.B. Contractor is responsible to notify the Contracting Officer at such times that testing isrequired. Do not proceed with any work until testing services have been performed andContracting Officer approves results of tests.C. The Government reserved the right to have 30 days after test samples have been madeprior to rendering a decision on such tests.D. The FAA reserves the right to direct re-testing in the event of failure and any re-testsshall be at the Contractor's expense.PART 2.00PRODUCTS [Not Used]01400-1